Installation Manual User guide

32
FT5000 - SITE PREPARATION AND INSTALLATION GUIDE
SECURING UNIT
It’s recommended that the unit be secured to the facility floor and plinth structure.
If a plinth was used, we recommend anchoring that structure first due to accessibil-
ity may be limited once the unit is mounted on the plinth. The footprint of the
cabinet floor allows for securing to either a concrete pad or plinth structure. An-
chor bolts may be too short to go straight from the cabinet to the floor, depending
how high the unit was raised to accommodate the wall opening. It is the customer
or their agent’s responsibility to determine how the unit is affixed to the facility.
Listed are some general considerations when securing the unit:
LEVEL FLOORING REQUIRE-
MENT
It is very important that the ATM
cabinet be located on flat, level
flooring! If the floor is not flat
and level, the cabinet bottom and/
or walls may become distorted
when the mounting bolts are tight-
ened down! This could prevent
the security vault door from clos-
ing!
1. What is the floor structure?
(concrete, wood, etc) Do you have
anchors, lag bolts, screws to secure
cabinet/plinth?
2. Is the unit a UL Level 1 Safe cabinet
or Business Hours? Will the floor
support the weight of the cabinet?
What is the plinth constructed of?
(If you build -concrete, metal, wood,
etc).
3. Is the inside floor level the same as
the outside ground? If inside floor
is higher or lower than outside, will
you need the optional 2-3/8” or 4-
3/4” plinths?
4. Is the floor level? Will the unit need
to be raised using the plinth/cabinet
leveling feet? (Leveling feet are for
minimal corrections to level cabinet)
5. Is exterior wall solid? (brick,
concrete) Wood framed?
Aluminum siding? Do you need to
insulate the wall cavity?
6. After cabinet is anchored, is the
control panel trim flush against the
exterior wall? Is the trim sufficiently
sealed to prevent moisture from
entering the control panel
electronics?
LEVEL 1 CABINET SAFETY
Level 1 cabinets are consider-
ably heavier than Business Hours
cabinets! Exercise extreme cau-
tion when moving Level 1 cabi-
nets! At least two persons should
work together to move the cabi-
net into position for mounting!
TOOL USE/SAFETY
Observe ALL safety precautions
for operating hand and power
tools! Wear eye and ear protec-
tion while operating the electric
drill!
USE A BACK-SUPPORT BELT
WHEN LIFTING AND MOVING
THE ATM!