Installation Manual User guide

12 Mark the anchor holes through the cabinet floor or mark around the plinth

structure using masking tape, pencil, etc. Remove the control panel trim and

slide the unit back inside.

13. Remove the unit from the plinth (if used). Align the plinth over the markings and

mark the anchor holes. Drill the anchor holes and secure the plinth (if used) to

the floor. Mount the unit back on the plinth (if used) and again slide the unit

forward towards the wall opening until the sleeve protrudes slightly out the

front exterior.

If no plinth was used, after drilling the anchor holes, again slide the unit forward

towards the wall opening until the sleeve protrudes slightly out the front exterior.

The next pages involve installing and securing the control panel trim.

Optional Plinths

Triton Systems now offers two (2) metal-constructed optional plinths w/

leveling feet. The plinths come in 2 heights: 2 - 3/8" (61 mm) and 4 - 3/4" (122

mm). Based on the height requirement needed, you can either:

1) Raise the unit with the leveling feet installed in the cabinet (Business

Hours and Level 1) using a 1/4" nut driver/socket wrench.

(Caution: The leveling feet are primarily for that purpose - leveling the ATM,

not to raise the unit by a significant amount).

2) Construct your own. A plinth is a platform on which the ATM rests or is

secured. A plinth enables the ATM to be installed at the required height

through the wall. If built, it must be no smaller than the base of the cabinet

and must be constructed of a material that is capable of supporting the

weight of the ATM.

3) Purchase an optional plinth (below). Raise the unit by a fixed amount (2 -

3/8" or 4 - 3/4") and still be able to adjust up using the plinths leveling feet

(adjustable crescent wrench - side access). Caution: Leveling feet are prima-

rily used for leveling the ATM, not to raise the unit by a significant amount.

(Note: Before installing the plinth, adjust the leveling feet a 1/4" (6mm) below

the platform to gain access with an open-end box wrench for additional adjust-

ments)

FT5000 - SITE PREPARATION AND INSTALLATION GUIDE