Installation Manual User guide

38
FT5000 - SITE PREPARATION AND INSTALLATION GUIDE
Speaker wires
4. After the control panel trim has
been secured, route the speaker
wires and topper AC power cord
through the grommet located in
upper right (Figure 3). Close the
topper light assembly until it snaps
in place (Figure 4).
5. Connect the light assembly AC
power cord to the power supply
mounted on the sleeve cabinet
door (Figure 5). Connect the
speaker wires to the audio input
circuit board located in the lower
right corner of the cabinet (Figure
6).
6. With 2 persons (inside/outside),
slide the whole unit back inside
until the control panel trim is flush
with the outside wall.
7. Before securing/anchoring the
cabinet, check to ensure the control
panel trim is flush against the
exterior wall. Minor adjustments
can be made using the cabinet
leveling feet.
8. Secure/anchor the cabinet to the
floor or plinth, if used. Cabinet/trim
installation is complete.
Figure 3. Cable slot holder.
Figure 4. Topper light assembly piv-
ots down.
Figure 5. Power supply.
Figure 6. Audio circuit board.