Installation Manual User guide

50
REMOVING/INSTALLING THE
NMD-100 DISPENSING
MECHANISM
The dispensing mechanism for the
FT5000 may be shipped hanging on
the side rails inside the security vault.
Several protective foam blocks have
been strategically placed behind and
along each side of the dispensing
mechanism to reduce any movement
during transit. The foam blocks must
be removed before the dispensing
mechanism can be removed. If the dis-
penser is shipped inside the cabinet,
follow the procedures below for removal.
FT5000 - SITE PREPARATION AND INSTALLATION GUIDE
4. Pull the dispensing mechanism out
of the cabinet until it reaches its
fully extended position. The left
slide rail has a locking pin that must
be disengaged to extend the rail.
(Figures 1 and 2)
Figure 1. Slide rail locking pin and
thumb screw location.
Figure 2. Dispenser fully extended on
its mounting rails.
1. Unlock and open the cabinet sleeve
door. Verify that the power switch
located on the power supply is in
the OFF (0) position. Close the
sleeve door.
2. Open the security vault and remove
all protective foam blocks from
around the dispensing mechanism.
3. Refer to Figure 1. Remove the trans-
port 5/32" Allen screws located on
top front of each slide rail. DIS-
CARD SCREWS AFTER RE-
MOVAL!
Locking pin
5. Refer to Figures 3 and 4. Discon-
nect the DC power, serial commu-
nications, and shutter cables from
the dispensing mechanism.
Figure 3. Shutter and serial cables
removed (left side of dispenser).
REMOVING THE DISPENSING MECHA-
NISM FROM THE CABINET
Allen screw
Serial communications cable connector
Shutter cable connector