Installation Manual User guide

51
Figure 4. AC power cable removed.
6. Using two persons, grasp the green
handles and lift the dispenser off
the rails and slide out of the cabi-
net. (Figure 5)
Figure 5. Lift dispenser off rails and
guide out of cabinet. Use 2-person
lift!
7. Place the dispenser in a safe loca-
tion where it will not get accidently
damaged.
8.* If installing the cabinet at this time,
follow the procedures provided in
“Site Preparation” section of this
manual.
NMD-100 DISPENSING MECHANISM REMOVAL/INSTALLATION
UNLOCKING
ELECTRONIC
LOCKS
ELECTRONIC LOCK. Upon arrival,
the combination of the lock should
already be preset to 1-2-3-4-5-6. To
unlock, enter the preset combination
and check for proper operation. After
each keypress, the lock will beep. After
the final digit has been entered, the
lock will beep twice, and the open
period will begin. When a valid
combination has been entered, the
operator will have approximately 3
seconds to open the lock. To open the
lock, turn the dial clockwise. After the
lock is opened, the door latch may be
turned and the safe opened.
AC power cable
connector
**WARNING**
Two persons recommended to re-
move the dispenser from the cabinet.
When removing dispenser from cabi-
net, use caution not to damage the
throat extension on front of dispenser
mechanism.