Installation Manual User guide

56
FT5000 - SITE PREPARATION AND INSTALLATION GUIDE
INSTALLING REAR SERVICE PANEL
The Rear Service Panel (RSP) is shipped
in its own container. Follow the proce-
dures for installing the RSP.
1. Carefully inspect the unit for any
shipping damage and report any
damage immediately to the
shipping company. Refer to the
warranty information in the User
or Service manual (as applicable)
for information about reporting
shipping damage.
2. If the unit is ON, enter
Management Function>System
Parameters>Shut Down the
Terminal. When prompted on the
screen, open the sleeve cabinet
and turn the power switch on the
power supply to the OFF (0)
position.
3. Look on top of the cabinet sleeve
and locate the five (5) mounting
screw holes as shown in Figure 2.
If there is a cable plug inserted,
remove it by pushing up from
inside the cabinet.
4. Remove the RSP and parts supplied
from its shipping container.
Remove the back panel of the RSP
by loosening the 2 thumb screws
located on top of panel and lifting
back panel up off its retaining slots
(Figure 3).
5. Place the service panel on top of
the cabinet sleeve as shown in
Figure 4. CAUTION: Panel
overhangs slightly on edge of
cabinet top when mounted. Panel
may tip over before routing cables
and inserting screws, so rest panel
back on cabinet top before
continuing with next steps.
Remove cable
access plug
(if inserted)
Figure 1. Rear Service Panel (RSP).
Figure 2. Mounting screw holes (5).
Figure 3. Loosen 2 thumb screws and
remove back panel.
Thumb
screws
Figure 4. Locate panel on top of
cabinet sleeve.