Installation Manual User guide

57
REAR SERVICE PANEL INSTALLATION
6. Route the power and data cables
through the cable access opening
shown in Figure 5. Feed cables into
cabinet (Figure 6) but DO NOT
connect at this time. Locate the
black plastic grommet included in
accessory box and insert in the
cable opening to protect cable run.
7. Slide service panel over mounting
screw holes and secure to cabinet
top using the five (5) Phillip screws
provided (Figure 7).
8. Place the paper roll on the spindle
ensuring the paper feeds from the
TOP of the roll as shown in Figure
8.
9. Insert the edge of the paper roll into
the printer take-up slot as shown
in Figure 9. The printer will
automatically grip and pull the
paper into the paper path. If the
paper feeds automatically, skip to
step 12; if the paper does not feed
automatically, continue with step
10.
10. Pull the pin located on the left side
of the printer bracket (Figure 10).
Rotate the printer assembly
upwards as shown in Figure 11.
11. The blue tension lever is located
on the right side of the assembly. It
must be in the closed position
(Figure 11 and insert). If not, move
the lever (moves in 3 positions) to
the closed position. Close the
printer assembly and retry to feed
the printer paper. If successful,
continue with step 12.
Figure 5. Feed cables through cable
opening on top of cabinet.
Figure 6. View of cables from inside
sleeve cabinet.
Figure 7. Secure RSP to top of
cabinet.
Figure 8. Insert paper roll on spindle
(paper feeds from TOP).
Insert grommet