Installation Manual User guide

58
Figure 14. Data cable connection.
FT5000 - SITE PREPARATION AND INSTALLATION GUIDE
12. Reinstall the back panel to the RSP.
Guide the back panel slots over the
2 tabs located on the bottom of the
front panel and rotate forward until
closed. Figures 12a/b. Tighten the
2 thumbscrews.
13. Connect the 2 power cables to any
8 pin connectors on the power
supply that are free (Figure 13).
14. Route the data cable (RJ-45
connector end) along the existing
cable run and connect to the
“Auxillary” port on the docking
board (Figure 14).
Figure 9. Paper feeds automatically
in take-up slot.
Figure 10. Pin location.
Figure 11. Printer assembly opened
and blue tension lever position
insert).
Figures 12a/b. Slots (above) fit over
tabs (bottom).
15. Turn the power switch on the power
supply to the ON (I) position.
16. Refer to Appendix B in the User
manual for program options.
Insert
Figure 13. Connect power cables.
Power cables connected
Front panel tabs
Back panel slots