User Manual Instruction Manual

124
MODEL FT5000 USER MANUAL
Restart Using Management Functions
B
1. Press and hold down the CTRL key
(blank key in lower right corner of
alphanumeric keypad). While
holding down the CTRL key, press
the number (1) key. Release both
keys. The Password Entry screen
appears.
2. Enter the Master or User password
at the Password Entry dialog
prompt. The Management
Functions main menu appears.
3. Select the System Parameters
option by pressing number (5) on
the alphanumeric keypad. The
System Parameters main menu
appears, as shown in Figure 7-5.
4. Select the Restart the Terminal
option by pressing number (5) on
the alphanumeric keypad. The
confirmation dialog appears, as
shown in Figure 7-6.
5. Press the Enter key on the keypad
to accept the option on the
confirmation dialog, which initiates
the restart operation.
6. The terminal software will re-
initialize. The terminal will
automatically attempt to clear any
error conditions during the start-
up sequence. This may take several
minutes. When complete, the top
menu appears.
Fig. 7-6. Restart terminal -
confirmation dialog.
After about a 30-second delay one of
two screens will appear:
• If the error condition was
successfully cleared, the Customer
Welcome screen will appear. The
terminal will resume normal
operations.
• If the error condition was not
successfully cleared (or another
error condition exists), the Terminal
Error screen will appear.
Fig. 7-5. Terminal system parameters.