User Manual Instruction Manual

39
CURRENCYHANDLING
OPENING THE REJECT VAULT
1. Insert the key into the vault lock.
To unlock the vault, apply inward
pressure on the key while turning
it clockwise to the stop position
(approximately a quarter-turn).
Open the vault by simultaneously
pressing the release button and lift-
ing the lid. Flip the lid back fully.
(Figures 4-17 and 4-18)
2. The reject vault is now open for
collecting any rejected bundle
notes. These will be present in the
folding tray. After retrieving any re-
jected bundle notes, lift the folding
tray and check underneath for any
rejected single notes. (Figures 4-19
and 4-20)
3. After removing any rejected notes,
close the vault lid. Fold the lid
down to its locked position. The
release button should “pop” out,
allowing the lid to mate cleanly with
the body of the cassette. Turn the
key counter-clockwise to lock the
vault.
INSTALLING THE REJECT
VAULT
Using the reverse of the steps taken to
remove the reject vault, slide the vault
back into its slot in the mechanism.
Make sure the vault is fully inserted.
Ensure the note cassettes are Locked
and In Service using the Cassette Close
procedures in Section 5, Management
Functions.
Figure 4-17. Key inserted.
Figure 4-18. Opening lid.
Figure 4-19. Bundle reject tray.
Figure 4-20. Single reject
compartment.