User Manual

47
FT7000
XP
- SITE PREPARATION AND INSTALLATION GUIDE
ENTERING THE COMBINATION
The electronic lock combination(s) consists of six digits. Upon arrival, the combination(s) of the lock
should already be set at 1-2-3-4-5-6. After installation of the unit has been completed, perform the follow-
ing steps:
1. Enter the preset combination(s) and check for proper operation. After each keypress, the lock will
beep. After the final digit has been entered, the lock will beep twice and the open period will begin.
2. Within four (4) seconds, turn the keypad clockwise to the open position.
3. After the lock is opened, the door may be opened.
Invalid Code Entry - Lock will beep three (3) times.
CHANGING THE COMBINATION
* IMPORTANT *
ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN.
If your unit is programmed for Dual Code (see PROGRAMMABLE FEATURES), each code must be changed
independently. Follow these instructions for each code change.
To change the combination of the lock, simply follow these directions.
1. Enter six (6) zeros.
2. Enter the current combination (initially set at 1-2-3-4-5-6).
3. Enter the new six (6) digit combination twice.
- If a mistake is made, wait thirty (30) seconds and repeat the first 3 steps.
4. Test lock combination several times before closing the door. The combination is now changed.
Valid Code Entry - Double signal after valid six (6) digit code is entered.
Invalid Code Entry - Triple signal and old code is still valid.
LOCKOUT FEATURE
The lock includes a WRONG TRY PENALTY lockout feature that prevents entry from unauthorized per-
sonnel. This feature performs as follows:
• Entry of four (4) consecutive invalid combinations starts a 5-minute delay period.
- LED flashes RED at ten (10) second intervals.
• At the end of the delay period, two (2) more consecutive invalid combinations will restart an additional
5-minute delay. Entry will not respond to a single keystroke during delay period.