Installation Manual Manual

21
MODEL RL2000 INSTALLATION MANUAL
4. Use a portable vacuum cleaner to remove any dust or debris that may have fallen into the holes during
the drilling process.
Drill anchor holes Blow out dust/debris.
Install Standard Anchors
Bolt ATM to Floor
1. Ensure the leveling feet are flush with the bottom of the cabinet. If necessary, use a screwdriver to
adjust the leveling bolts inside the cabinet (near the four corners) so that the leveling feet are flush with
the bottom of the cabinet.
2 Move the ATM into position for mounting by aligning the base over the four holes drilled in the
previous procedure.
3 Place an anchor bolt through the cabinet base and into one of the mounting holes. Use a ball peen
hammer to tap the bolt completely into the hole.
IMPORTANT: If the anchor bolt “falls” into the hole without needing to be tapped in, the hole is too
large! The mounting-hole pattern will have to be moved and redrilled using smaller holes as
necessary to achieve a snug fit.
Place anchor bolts in mounting holes. Tap anchor bolts into mounting holes.