Installation Manual Manual

MODEL RL2000 INSTALLATION MANUAL

Route AC Power and

Communication Cable

NOTE: Before you start, unlock and open the control panel. Verify that the power switch on the unit’s

power supply is in the OFF (0) position. Close the control panel.

1. Obtain the AC power cord that is located in the accessory box. From the exterior of cabinet, feed the

small end of cable through a cable access hole (lower part of cabinet).

NOTE

The Power Cord interface cable is located inside the vault area (Dispenser location) of the cabinet.

To gain access and connect the power cord included in the accessory box, you may have to

remove the dispenser.

Main cable

access hole

2. Connect and route the power cord in the unit as shown in figure at right.