Use and Care Manual

Troubleshooting

Problem Possible cause Solution

Red charging LED does not illuminate and battery not

charging

Battery not fully seated Clean battery socket of charger

Charger not powered Recheck mains connection

Battery pack has low capacity

Battery not being fully charged Charge the battery until the charger indicates a full charge

Battery pack has been charged over 100 times and capacity

has started to reduce

This is normal for battery packs. Contact your Triton dealer

to purchase a replacement battery pack

Drill cannot be switched on (trigger switch does not move)

The forward/reverse switch may be in the middle (‘locked’)

position

Slide the forward/reverse switch either to the left or right

Drill does not start when on/off trigger switch is depressed

Battery completely discharged Recharge battery or replace with a fully charged battery

Defective battery Replace battery

Machine defective Contact your Triton dealer or authorised service centre

Screws do not reach deep enough into the workpiece

Not enough torque; torque clutch setting too low Choose a higher torque setting

Low battery voltage Recharge battery or replace with a fully charged battery

Screws are driven too deep into the workpiece surface Too much torque; torque clutch setting too high Choose a lower torque setting

During masonry drilling the drill bit does not penetrate

the wall

Unsuitable or blunt drill bit Replace drill bit with a new high quality masonry drill bit

Drill bit too large See ‘Speciﬁcations’ for maximum drilling capacities

Drill not set to hammer mode

Rotate mode selector to switch the machine into hammer

drill mode (see ‘Mode Selection’)

940454_Z1MANPRO1.indd 8 25/09/2014 17:25