Operation Manual

EPTEPLEPTERUEPTEPLEPTE
90
CZ
Symptom Problem Suggested remedy
Saw will not operate Power lead not plugged in
Ensure that the power lead is connected to the
power supply
Power fault, fuse or circuit breaker tripped Check the power supply
Brushes worn or sticking
Disconnect power, open brush caps and ensure brushes move freely in the holders. Check whether
brushes require replacing as outlined in the maintenance section.
Lead damaged Use authorised service centre** to repair or replace the lead
Faulty switch Use authorised service centre** to repair or replace the switch
Faulty motor Use authorised service centre** to repair or replace the motor
Poor performance Extension lead too long or undersized
Use extension lead heavy enough to carry the
current
Blunt or damaged blade Re-sharpen or replace blade
Motor is overloaded Reduce pushing force on saw. Ensure the cut isn’t closing and pinching the blade.
Tool is overheating Turn off the tool and let it cool down to room temperature. Inspect and clean the ventilation slots.
Vibration or abnormal noise Accessory not secured
Ensure that the saw blade is fully tightened in the
arbor washers
Moving parts excessively worn Use authorised service centre** to repair or replace
Mechanical obstruction Use authorised service centre** to repair or replace
Armature has shorted sections Use authorised service centre** to repair or replace
Motor runs but blade won’t spin Blade retaining nut is loose
Tighten blade retaining nut, ensure the arbor
washers are correctly tted
Broken gear shaft or teeth
Use authorised service centre** to repair or
replace
Saw depth adjustment not holding Depth adjustment lever requires tightening
Reposition the depth adjustment lever as
described in 'Adjusting the depth locking lever
tension'
Heavy sparking occurs inside motor housing Brushes not moving freely
Disconnect power, remove brushes, clean or
replace
Armature short circuited or open circuited Use authorised service centre** to repair or replace
Commutator surface not clean Use authorised service centre** to repair or replace
Retractable guard will not close, or is slow to close Return spring detached or broken
Re-attach or replace spring (use only genuine
Triton replacement parts)
Guard is bent Straighten it or contact authorised service centre** to repair or replace
Mechanism fouled by sawdust Clean and lightly lubricate fouled mechanism
If a problem cannot be resolved using the above advice do not tamper with the saw - visit www.tritontools.com to nd your nearest
Triton ofce for assistance.
** Visit www.tritontools.com to nd your nearest authorised service centre.
Řešení problémů
330135_Z1MANPRO1.indd 90 29/09/2014 15:54