Instruction Manual

5
GB
the power tool. If damaged, have the power tool
repaired before use. Accidents are caused by
poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g. Use the power tool, accessories and tool bits in
accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Failure to use
the tool for its intended purposes could result
in a hazardous situation and may invalidate the
warranty.
5. SERVICE
a. Servicing of your power tool must be carried out
by a qualified technician, using only identical
replacement parts, ensuring that safety of the
power tool is maintained.
Safety Instructions / Assembly
ASSEMBLY
FITTING THE SAW BLADE
• Only use 235mm blades, with a kerf between
2.2 and 3.5mm, designed for circular saws with
a no load speed rating of at least 4500min
-1
. Do
not fit high speed steel blades or abrasive discs
to this tool. The use of incorrect accessories may
invalidate the warranty.
• Do not t inferior blades. Regularly check the
blade is flat, sharp and free of cracks or defects.
1. Ensure the saw is disconnected from power.
2. Unscrew the handle half a turn to release the
spanner from the storage position, as shown.
Press the Spindle Lock (16), loosen and remove
the blade retaining bolt and outer flange washer
from the arbor shaft.
3. With the saw set at full cut depth, retract the
guard and fit the blade neatly onto the shaft
against the inner flange washer.
Note that the 25 - 16mm reduction bush must
fit neatly in the arbor hole. The blade teeth must
point in the same direction as the arrow on the
fixed guard housing.
4. Replace the outer flange washer and retaining
bolt and tighten with the spanner while
depressing the spindle lock. Do not over-tighten.
Return the spanner to the storage position and
tighten the handle.
5. Regularly check that the retaining bolt is tight.
NOTE: The arbor is fitted with a 16 - 25mm
diameter spacer bush, which must be removed if
fitting a blade with a 16mm arbor.