Operation Manual

6-53
Operation Panel
Channel (Channel settings)
This sets the Channel to be used in the wireless LAN.
1 In the Custom Setup menu, press  or  to select Channel.
2 Press [OK]. The Channel screen appears.
3 Enter the Channel number using the numeric keys,  or .
4 Press [OK]. The Custom Setup menu reappears.
Netwk Authentic. (Network Authentication setting)
This sets the authentication method to be used when connecting to an access point.
1 In the Custom Setup menu, press  or  to select Netwk
Authentic..
2 Press [OK]. The Netwk Authentic. screen appears.
The available authentication methods are as follows:
Open
Shared
WPA-PSK
WPA2-PSK
3 Press  or  to select the desired authentication method.
4 Press [OK]. The Custom Setup menu reappears.
Encryption (Encryption settings)
This selects the encryption settings.
1 In the Custom Setup menu, press  or  to select Encryption.
2 Press [OK]. The Encryption screen appears.
The following operations are possible:
• Data Encryption (Data Encryption setting)...6-54
• WEP Key (WEP Key settings)...6-54
• Preshared Key (Preshared Key settings)...6-55
Note The Channel can be set between 1 and 11.
Channel: a b
(1 - 11)
/10-
Note WPA-PSK and WPA2-PSK are only displayed when
Infrastructure has been set as the Connection mode
(Switch between connection modes) on page 6-52.
Netwk Authentic.: a b
********************-
2 *Shared
3 WPA-PSK
1 Open
Note This setting is not displayed when the setting for Netwk Authentic. (Network Authentication setting) on page
6-53 is set to use an authentication method other than Open, Shared, WPA-PSK and WPA2-PSK, using Utility.
Note WEP Key is displayed when Netwk Authentic.
(Network Authentication setting) on page 6-53 is set to Open
or Shared.
Preshared Key is displayed when Netwk Authentic.
(Network Authentication setting) on page 6-53 is set to WPA-
PSK or WPA2-PSK.
Encryption: a b
********************-
2 WEP Key
[ Exit ]
1 Data Encryption