Operation Manual

Printing Operation 3-5
3 Press Z. Each time you press U or V, the selection changes. Refer
to the explanations below when specifying the settings.
If you are using NetWare, AppleTalk, IPP, SSL Server or IPSec
to connect to a network, you must enter an administrator ID. By
default, the administrator ID is the numeric part of your printer's model
name. If you use
CLP 4626, enter "5300".
If you are using NetWare, AppleTalk, IPP, SSL Server or IPSec
to connect to a network, you must enter an administrator password.
By default, the administrator password is the numeric part of your
printer's model name. If you use
CLP 4626, enter "5300".
Set this item to On when you connect to a network using NetWare. In
submenu, frame mode can be selected from Auto, 802.3,
Ethernet-II, SNAP and 802.2.
AppleTalk must be activated (On) for networking with Macintosh
computers.
Set this item to On when you connect to a network using IPP.
Set this item to On when you connect to a network using SSL
Server. Submenu has items including DES, 3DES, AES, IPP over
SSL and HTTPS.
Set this item to On when you connect to a network using
IPSec.
Continued on next page.
ID
_
Password
_
>NetWare >
On
>AppleTalk
On
>IPP
Off
>SSL Server >
Off
>IPSec
Off