Item # 45-6066 3-in1 Rotating Table 3 BILLIARDS AIR HOCKEY TABLE TENNIS 84 Inch
! WARNING: Rotating game should be done under adult supervision. Rotating table may cause a pinching hazard for young children and pets. Please exercise caution. At least two adults are needed to put this game table together. 1. Read all instructions: All the safety and operating instructions should be read carefully before this table can be operated or played. 2. Caution: This is not a toy and is intended for use under the supervision of adults.
74
Step 1 Remove all components from the carton. NOTE: Parts are packed inside the table top. Remove the pool table surface (#2), inside the table top you will find all the parts needed to assemble your table. When all the parts are out of the table top, replace the pool table surface. Attach the pool table surface by using the screws (#18). Step 2 FIG: 2A Screw 2 lock pins (#5) into leg pedestal (#3) predrilled holes with screws (#19). Attach the catcher box (#4) with screws (#20) into predrilled holes.
Step 3 Identify part (#12), leg base to FIG: 3C, add glue drops to both sides of image. 27 12 FIG: 3A Assemble the legs (#9). Run a bead of glue (#27) in the groves on the inside edges of the leg (#9). FIG: 3B Slide leg brace (#11) into glued groves on leg (#9). FIG: 3C Screw leg base (#12) to bottom end of leg using screws (#20). Screw leg leveler (#26) into leg base (#12). Repeat this step for all 4 legs, 2 of (#9) & 2 of (#10). Step 4 Attach the leg pedestal (#3) to the legs (#9) & (#10).
Step 5 Assemble the outside rails (#14) by screwing the apron-end board (#13) to each end of the outside rail (#14) with screw (#20). Step 6 With the help of another person attach the outside rails (#14) (flat side up) to the assembled leg pedestals by aligning the holes in the outside rails (#14) with the predrilled holes in the leg using screw (#22).
Step 7 Preparing the table top for mounting. The threaded shaft in the cabinet-hockey (#1) cannot be removed, be sure to pull it out as far as possible, about 2 to 3 inches on the end with the electric plug. On the opposite end, slide ½” washer (#24) and ½” plastic washer (#25) onto the ½” hex bolt (#23). Insert the ½” hex bolt (#23) into the threaded shaft. Screw the bolt into the shaft leaving about 2 to 3 inches of the hex bolt exposed when the bolt is secured into the threaded shaft.
Step 8 Attach top side panel (#15) to the assembled leg pedestal (#3) by aligning the holes in the side panel (#15) with the predrilled holes in the top of the leg pedestal (#3) with screw (#20). Step 9 Assemble the hockey striker (#35) by attaching the hockey felt (#36) by removing the protective paper and adhering the hockey felt (#36) to the striker (#35).
Step 10 Place the tennis top-support (#29) in the center of the table. Unfold the tennis surface-B (#17) and tennis surface-A (#16) and place on the table surface. WARNING: Tennis top must be removed before rotating table top! Trouble Shooting: If the pool table side is not level first try to level by using the leg levelers on each leg. Most of the time the table can be easily leveled using this method.
BILLIARDS: After the break, regardless of whether any balls were pocketed on the break, the table is Open, with the choice of stripes or solids determined by the next legally pocketed ball. In the course of play, a player must call each shot in advance, by indicating the ball to be made and the pocket into which it will be made. It is not necessary to indicate details such as cushions, banks, caroms, etc. Failure to make the shot as called results in a loss of turn.
TABLE TENNIS: In singles, the server first makes a good service and then the receiver makes a good return. Thereafter, server and receiver alternately each make a good return. In doubles, the server first makes a good service and the receiver returns the ball. Then the partner of the server makes a good return, followed by the partner of the receiver returning the ball. Thereafter, each player alternately in that sequence makes a good return.
Be sure to check out all the exciting games has to offer. Visit our web site at: www.triumphsportsusa.com 90 day TSU Game Warranty All TSU games have a 90 day from date of purchase warranty. This warrants the retail purchaser for any of the TSU games purchased to be free from any defects in materials and construction for 90 days from date of purchase. Normal play wear and usage is not covered under the warranty or improper use of any TSU game. This will void any and all TSU warranty.