User's Manual

2. After the TRIVA Smart Safety Tag has been decommissioned, the user can remove the
device from the surface by simply prying the adhesive off with a flathead screwdriver.
3. If replacing the TRIVA Smart Safety Tag, the user can again scan the QR code of the
TRIVA Smart Safety Tag or enter the unique identifier displayed on the TRIVA Smart
Safety Tag. The user will then have an option to replace the TRIVA Smart Safety Tag.
The user will then scan the new TRIVA Smart Safety Tag QR code or enter the unique
identifier of the new TRIVA Smart Safety Tag that will be replacing the existing TRIVA
Smart Safety Tag.
4. The user can remove the existing TRIVA Smart Safety Tag as described in step 2 and
mount the new TRIVA Smart Safety Tag in its place. Ensure that the surface is still flat
and clean where there new TRIVA Smart Safety Tag will be mounted.
Field Testing a TRIVA Smart Safety Tag
The TRIVA Smart Safety Tag can be field tested utilizing a mobile/web application associated
with TRIVA, Inc. To test that a TRIVA Smart Safety Tag is powered on and transmitting:
1. The user will open the scan function of the mobile application
2. The user will ensure they are in close proximity to the TRIVA Smart Safety Tag being
field tested.
3. The user will press the scan button, and the mobile application will list all TRIVA
Smart Safety Tags discovered.
4. If the TRIVA Smart Safety Tag is not discovered during the scan, try to move closer to
the TRIVA Smart Safety Tag and try again.
5. If the device is not detected again, the device is most likely not transmitting due to a
dead battery or other defect. The user can scan the devices QR code to pull up the
last time the TRIVA Smart Safety Tag was discovered.
6. In the case that the scan does not detect the device being field tested, a
replacement TRIVA Smart Safety Tag is most likely needed.