Trojan Battery User Guide

5
USER’S GUIDE
5
01 Safety
Since batteries deliver large amounts of power that can cause injury and even death, observing safety
rules is of paramount importance. For your safety and the safety of those around you, please observe the
following checklist when working on or around batteries.
Always Never
Always wear protective clothes, gloves & safety goggles Never smoke near batteries
Always use insulated tools when working on batteries Never wear jewelry or other metal objects when working on
or around batteries
Always check connections for proper torque Never make direct contact with the electrolyte (sulfuric acid). If this occurs,
ush with large amounts of water.
Always charge batteries in well-ventilated areas Never place objects on top of batteries, which can cause a short circuit
Always keep sparks and ames* away from batteries Never add acid to a battery
Always use largest cable size of shortest length to minimize voltage drop Never charge a frozen battery
Always ensure plates are covered in water before charging Never charge a ooded battery without securing vent caps on the cells
Always make sure charger is set for the appropriate battery type (ooded,
AGM or gel)
Never charge a battery when the temperature is above 122°F (50°C)
Always charge batteries before installing Never store batteries unless they are fully charged
Always neutralize acid spills with baking soda and water Never leave an acid spill unattended
WARNING Risk of re, explosion, or burns. Do not disassemble, heat above 70° C (160° F),
or incinerate.
02 Equipment Needed
Before installation or maintenance of your batteries, have the following equipment available:
î Proper personal protective equipment
(eye protection and acid resistant gloves)
î Distilled or treated water (deionized or
reverse osmosis)
î Insulated wrench
î Baking soda
î Terminal protector spray
î Voltmeter
î Hydrometer (deep-cycle
ooded/wet batteries)
î Discharge tester (if available)
î Battery charger