OWNER’S MANUAL
ASSEMBLY 1/4-20 x 2 1/4” Hex Bolt RH. Handle Brace 1. Remove components from carton and place spreader upside down on a padded surface. Install LH. & RH. handle braces to frame as shown using four (4) 1/4-20 x 2 1/4” hex bolts and nuts but do not tighten. 1/4-20 Hex Nut 5/32 Dia x 2” Cotter Pin LH. Handle Brace Drive Wheel 1/8 Dia x 1” Cotter Pin Free Wheel 2. Install drive wheel onto right-hand end of axle (you can identify the drive wheel by the cotter pin hole drilled in the hub).
Remove Caution Label Control Knob & Wire Assembly 4. Feed control knob/wire through the T-handle until spring touches the round hole. CAUTION: Do Not Compress Spring At This Time. Feed wire through the square handle tube. Be sure wire passes above the bolts in the handle brace. Secure T-handle to the tube with (1) 1/4-20 x 2 1/4” hex bolts, (2) washers, and (1) hex nut in the holes. Remove caution label and push the thumb release toward the centre and push down knob and shutoff spring until knob latches.
OPERATION 1. Check the product package for the rate setting, and recommended swath width. Turn the spreader OFF by pushing the control knob in. Rotate the rate cam to the proper setting. 2. The rate setting is adjusted by rotating the rate cam to the desired setting. The rate cam locks at each setting. 3. Always fill the spreader on the driveway or path-not on the lawn. Make sure spreader is in the “OFF” position. Empty after each use. 4.
HOW TO DETERMINE SPREADER SETTINGS AND SPREAD WIDTH Two major factors should be considered when determining correct spreader settings of any product: 1. The product application rate, or the amount of material applied per 500 square metres. 2. The effective pattern width, or the actual width in which material is applied. Label settings are a guide and can be affected by numerous factors. The Trojan 30 is factory calibrated. However, calibration should be checked occasionally to assure optimum performance.
RATE SETTING CONVERSION The following provides approximate settings for those units listed.
MAINTENANCE 1. Never store unused material in spreader. Return unused product to its original container. Oil Impeller Shaft Bearing In Hopper 2. Wash spreader thoroughly after each use and dry completely in sun or heated area. Oil 3. Oil the axle bearings, impeller shaft bearing in hopper, control knob in T-handle. 4. Remove gear cover and wash gears thoroughly. Oil all bearing areas and face of gear teeth. Reinstall gear cover. 5. Gear mesh should be checked on a regular basis during high use periods.
Parts List 23 22 27 24 25 21 26 1 1A 20 28 2 19 7 3 18 4 5 6 17 15 14 8 16 9 10 12 13 PART OF OUR SERVICE IS PROVIDING REPLACEMENT PARTS. Parts may be obtained 1. SPREADER MODEL NUMBER 2. SPREADER NAME 11 Sherriff Amenity The Pines Fordham Road IF YOUR LOCAL DISTRIBUTOR CANNOT SUPPLY PARTS, CONTACT: www.sherriff-amenity.com 4.
