Tron 5.5E Manual

Final setup and pre-ight check.
1. Disconnect your Motor
wires from the ESC!
2. FBL controller should be to
set to the mode where you
can level your servo center
position and, or swashpla-
te level mode.
3. Fine tune your servo center
position as precise as you
can by the position of the
servo horns. For netuning
use Sub trims in the FBL
software.
4. Adjust your linkage from
the servos to the swash-
plate as shown in the
illustration. (90 degree)
5. Adjust your swashplate
to Blade grip linkage to
achieve 0 pitch at center
stick position.
6. Continue setup as requi-
red in your FBL controller
software.
41
Zero degree pitch at center position.
• Zero degree pitch at center stick position
• Anti rotation arms at 90 degrees
• Cyclic servos at 90 degrees position
Important note!
The ball links have a larger and a
smaller diameter. Always make sure the
larger diameter is pointing towards the
pivot ball when assembling!