Operation Manual

- 3 -
Risk of fire!
Do not use the device near hot surfaces.
Do not locate the device in places exposed to
direct sunlight, Otherwise, it may overheat and
become irreparably damaged. Do not operate
the device in a vehicle that is standing out in the sun.
Do not leave the device unattended when in use.
Do not cover the fan's ventilation slots when the
device is switched on.
Do not place any open sources of fire, like candles,
on the device.
Due to high crossover resistances heating of the
plug in connector can result when using the ca-
bles with a 12 V vehicle plug.
Notice regarding disconnection from
the power supply
This device's on/off switch does not completely
disconnect the device from the vehicle's power
and/or the battery. When the vehicle plug is
connected power is still supplied to the device.
To completely disconnect the device from the
vehicle power supply the 12 V vehicle plug must
be removed from the 12 V vehicle receptacle.
Risk of personal injury!
Keep children away from the connecting cable
and the device. Children frequently underestimate
the dangers of electrical appliances.
Do not operate the device if it has fallen or is
damaged. Have the device checked and repaired
if necessary by qualified technicians.
Technical data
DC Input
Voltage: 12 V
Maximum voltage: 15,5 V
Maximum power
consumption: 20 A
Low voltage alarm: at 10,6 ± 0,3 V
Low voltage shutdown: at 10 ± 0,3 V
Over voltage shutdown: at 16 ± 0,5 V
AC Output
Voltage: 220-240 V
~
50 Hz
Output power: 0,65 A
Continuous load: 150 W (> 4 h)/
170 W (30 min)
Peak load: 300 W (0,1 s)
Efficiency: approx. 85 %
Output wave form: modified sine
Overload protection: 200 W (+/- 10%)
Temperature Switch-off: 65°C
(at 50 W +/- 5%
Loading)
USB Port
Voltage: 5 V
Output current: 500 mA
Fusing
Cable fuse: 20 A Car-type fuse
General data
Measurements (without vehicle plug)
(L x B x H): 181 x 75 x 61 mm
Weight: 460 g approx.
Operating temperature: 5°...40°C
Operational humidity: 0 - 80 %
(relative humidity -
no condensation)
Subject to technical changes!
IB_61124_TSW150A1_GB_LB3.qxd 04.01.2011 16:59 Uhr Seite 3