Installation Guide

P4
Mounting Plate
J Hook
Fan Assembly
Canopy
Hanging Base
OFF
OFF
OFF
Turn off power at breaker
box to avoid possible
electrical shock.
Use metal outlet box suitable
for fan support.
Outlet box must support 35 lbs min.
Remote
Receiver
WARNING: Fan should be at least 7 feet from the floor
Installing mounting plate to ceiling outlet box
1. HANGING SYSTEM INSTALLATION
CAUTION:
Oscillating device located
at hanging base is fragile,
do not damage or bend
oscillating parts (cam/arm/motor)
during installation
Note 1: Note 2: Note 3:
cam
motor
arm
Hanging Base
Mounting Plate
Outlet Box
House Wires
1A.
Pull house wires from outlet box
through the center hole of
mounting plate
1B.
The screw hole between
is for finding out
. Adjust mounting plate by
aligning 2 slots of mounting plate
with screw holes on outlet box (see
fig.1).
direction
marks intended air
direction
1C.
Attach mounting plate to outlet box
by securing with screws included
with the outlet box and washers
from the hardware bag through 2
out of 6 slots on mounting plate.
1D. Hanging the fan
Lift the fan assembly and hang onto the through oval-shaped hole on mounting plate.
This will permit you to make the electrical connections without having to hold the fan up as well.
J hook
Direction Mark
Blade Oscillating Direction
Outlet Box
Screw hole
Mounting slot
Intended Air Ditection
Outlet Box
Mounting
Plate
( fig.1)
IMPORTANT: Align Mounting Plate to desired oscillator direction now.