Installation Guide

P6
Screws on
Mounting Plate
Canopy
3. HANGING BASE AND CANOPY INSTALLATION
3B.
Push up canopy and secure to hanging base with 4 set screws from hardware bag.
3A.
Carefully lift the fan assembly away from the hook on mounting plate.
Slightly rotate hanging base until two screw heads are in L type slots.
Attach other 2 set screws from hardware bag to secure hanging base and mounting plate (these will be
the remaining 2 out of 4 set screws for securing hanging base to mounting plate).
1
2
Align direction marks direction markson mounting plate with on hanging base.
Push up hanging base until 2 set screws pre-installed on mounting plate are engaged with L type slots
on hanging base.
Make sure all 4 set screws are firmly secured.
(see fig.1)
(see fig.1)
(see fig.2)
(see fig.2)
3
4
Note:
Mounting Plate
Hanging Base
Hanging Base
NOTE:
After above steps, please check if air direction is the same as intended direction. If not, please take below
steps for minor adjustment:
1. Remove all 4 set screws from hanging base.
2. Use direction marks on hanging base as center. Rotate hanging base (45 degree to the left or 45 degree
to the right) for minor adjustment.
3. Attach 2 set screws to two diagonal holes on mounting plate where 2 L type slots on hanging base are to
engage. After minor adjustment, direction marks on mounting plate and hanging base may not be aligned.
(see fig.1 & fig.2)
45
o
45
o
Mounting Plate
Hanging Base
1
4
New air direction
New air direction
( fig.1)
( fig.2)
3
Direction Marks
( fig.1)
( fig.2)
2
2