Installation Guide

P7
4. SET UP MOTOR POSITION
NOTE:
Fan motor is at 0 degree when taken out from the carton, no need to change motor angle if intend
to use the fan at 0 degree.
HI
MED
LOW
OFF
OSC
MED:Fan middle speed
HI:Fan high speed
LOW:Fan low speed
OFF: For fan speed and oscillation
OSC: Button for ON/OFF oscillation
(*this button only functions when fan is in operation)
5. BLADE INSTALLATION
5A.
Attach blade to blade
with screws & washers provided
in hardware bag. Make sure that
all screws are firmly tightened.
holder
Thread the cap
to motor shaft until fully tightened.
(*This is reverse threaded.)
5C.
counter-clockwise
Blade
Flywheel
There is and for aligning 0/45/90 degree motor
position (see fig. 1)
Remove set screw and spring washer from motor yoke. (see fig. 2)
Adjust motor angle by aligning
.(see fig. 2)
Secure set screw and spring washer removed from step 4A back to motor yoke. Make sure set screw is
firmly tightened.(see fig. 2)
one indicating line on downrod yoke three on motor yoke
one out of three indicating lines (0/45/90) on motor yoke with
indicating line on downrod yoke
4A.
4B.
4C.
Cap
Motor Yoke
For 0 degree
Downrod Yoke
Motor Yoke
Downrod Yoke
Set Screw
Set Screw
Set Screw
For 45 degree
For 90 degree
Motor Yoke
Downrod Yoke
Downrod Yoke
Set Screw
Motor Yoke
( fig.1)
( fig.2)
Blade Assembly
Indicating Line(1)
Indicating Line(3)
Beveled Motor
Shaft
7. Turn on the power - your fan is ready for operation.
6. REMOTE
Attach blade assembly to flywheel,
.
5B.
aligning beveled center hole on
flywheel with beveled motor shaft
before attachment