Installation Guide

ManualsBrandsTroposAir ManualsKitchenMustang II 18 in. Dual Motor Oscillating Indoor/Outdoor Rubbed Bronze Ceiling Fan

3MT18-2M

10.0 KGS.

22.0 LBS.

Net weight

This instruction contains 6 pages:

Page 1: Foreword

Page 2: Unpack and inspect parts contained

Page 3: Notes before installation and Hanging system installation

Page 4: Wire connection

Page 5: Hanging base & Canopy installation / Set up m

Page 6: Blade / L

otor position

ight kit installation and Remote & Setting

WARNING : Read and follow these instructions carefully and be mindful of all warnings shown throughout.

Mustang II

Owner’s Manual

Toll Free: 1-855-676-7247

Summary of content (7 pages)

PAGE 1
Owner’s Manual Mustang II 3MT18-2M This instruction contains 6 pages: Page 1: Foreword Page 2: Unpack and inspect parts contained Page 3: Notes before installation and Hanging system installation Page 4: Wire connection Page 5: Hanging base & Canopy installation / Set up m otor position Page 6: Blade / L ight kit installation and Remote & Setting Net weight UL 10.0 KGS. 22.0 LBS.
PAGE 2
READ AND SAVE THESE INSTRUCTIONS WARNING : TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, PLEASE OBSERVE THE FOLLOWING : 1 ] . To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before beginning. 2]. To avoid possible electric shock, be sure electricity is TURNED OFF at the main power box before wiring. All electrical connections must be made in accordance with local codes, ordinances and/or the National Electric Code.
PAGE 3
Unpack and inspect fan carefully to be certain all contents are included.
PAGE 4
WARNING: Fan should be at least 7 feet from the floor Note 1: Note 2: Turn off power at breaker box to avoid possible electrical shock. Use metal outlet box suitable for fan support. Outlet box must support 35 lbs min. Note 3: CAUTION: Oscillating device located at hanging base is fragile, do not damage or bend oscillating parts (cam/arm/motor) during installation Hanging Base OFF OFF OFF motor arm cam 1.
PAGE 5
2. WIRE CONNECTION 2A. Attaching safety cable to ceiling joist Use wood screw, spring washer, and flat washer from hardware bag. Pass wood screw through closed loop of safety cable. Secure wood screw to ceiling joist through any available slot on mounting plate. Make sure safety cable has been tightened securely. CAUTION: THE WOOD SCREW AND ITS SUPPORT MUST BE ABLE TO FULLY SUPPORT THE WEIGHT OF AT LEAST 100 LBS.
PAGE 6
3. HANGING BASE AND CANOPY INSTALLATION 3A. Carefully lift the fan assembly away from the hook on mounting plate. 1 Align direction marks on mounting plate with direction marks on hanging base. (see fig.1) 2 Push up hanging base until 2 set screws pre-installed on mounting plate are engaged with L type slots on hanging base. (see fig.1) 3 Slightly rotate hanging base until two screw heads are in L type slots. (see fig.
PAGE 7
5. BLADE INSTALLATION 5A. Attach blade to blade holder with screws & washers provided in hardware bag. Make sure that all screws are firmly tightened. 5B. Attach blade assembly to flywheel, aligning beveled center hole on flywheel with beveled motor shaft before attachment . 5C. Thread the cap counter-clockwise to motor shaft until fully tightened. (*This is reverse threaded.) Blade Beveled Motor Shaft Flywheel Blade Assembly Cap 6. LIGHT KIT INSTALLATION 6A.