Installation Guide

P4
2B. Making electrical wire connection
Follow diagram below and make sure that all exposed wires are secured inside wire nuts.
Note: Wires from house may vary in color and may not include ground wire (green).
After wiring is completed, collect wires neatly inside hanging base.
2. WIRE CONNECTION
Use wood screw, spring washer, and flat washer from hardware bag. Pass wood screw through closed loop of safety cable.
Secure wood screw to ceiling joist through any available slot on mounting plate. Make sure safety cable has been
tightened securely. CAUTION: THE WOOD SCREW AND ITS SUPPORT MUST BE ABLE TO FULLY SUPPORT
THE WEIGHT OF AT LEAST 100 LBS.
2A. Attaching safety cable to ceiling joist
*White wire from house to white wire from receiver
*Black wire from house to black wire from receiver
*Ground wire from house to green wire from hanging base and from mounting plate
*Secure with twist - lock wire nuts. (Included)
Hanging Base
From House
From Fan
(Pre-wired in factory)
From Receiver
White
Black
Green
( Green )
( for ground wire )
From Hanging Base
From Mounting Plate
( Green )
White
Black
Blue
White / neutral
Black / hot
Gray
White
Black
Black
( Hot )
( Neutral )
(Hot)
(Neutral)
OSC.
MOTOR
Canopy
Safety Cable
Remote
Receiver
Wire Form House
( Light )
White
Red
Capacitor
Remove battery cover.
Slide code switch randomly using a small screwdriver or ball point pen to slide each switch firmly up or down.
Slide code switch for light ON/OFF (marked as X), or DIMMING (marked as D) function.
Install 9V DC battery.(Included)
Install battery cover on transmitter.
1.Setting the code on the TRANSMITTER
1
2
3
4
5
2C. Setting code switches for transmitter
Remote controls are tuned to operate together using 4 switches for 16 possible code combinations.
Important! This fan includes 2 CFL bulbs, so the code switch should be at X position (ON/OFF).
You may switch code at D position (DIMMING) once incandescent bulbs are installed.
!
Warning! CFL bulbs are not applicable to the remote with dimming function.
1
4
5
D: for light dimming
(for incandescent bulbs )
X: for light ON/OFF
(for CFL bulbs)
Transmitter
Code Switches
1
2
3
4
2
X
D
ON
3
1
2
3
4
X
D
ON
Safety cable
Mounting Plate
Outlet Box
Safety cable
Flat Washer
Spring Washer
Wood Screw
Outlet Box