Installation Guide

WARNING : TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY

TO PERSONS, PLEASE OBSERVE THE FOLLOWING :

READ AND SAVE THESE INSTRUCTIONS

1]. To ensure the success of the installation, be sure to read the instructions and review the diagrams

thoroughly before beginning.

2]. To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring.

All electrical connections must be made in accordance with local codes, ordinances and/or the

National Electric Code. If you are unfamiliar with the methods of installing electrical wiring and

products, require the services of a qualified and licensed electrician as well as someone who can

check the strength of the supportive ceiling members and make the proper installations and

connections.

3]. Make sure that your installation site will not allow rotating fan blades to come in contact with any

object. Blades should be at least 10 feet from floor when fan is in operation.

4]. If possible, mount ceiling fan on a ceiling joist - the joist must be able to support the motion and weight

of the moving fan. If the fan will be mounted on a ceiling outlet box, a 4" x 2-1/8" deep METAL octagon

box is required ; one UL listed as " suitable for fan support ". The box and its supporting members must

not be able to twist or work loose. DO NOT USE PLASTIC BOXES. Installation on a concrete ceiling should

be performed by qualified personnel.

5]. Blades should be attached after motor housing is hung and in place. Fan motor housing should be

kept in carton until ready to be installed to protect its finish. If you are installing more than one ceiling

fan, make sure that you do not mix fan blade sets.

6]. After making electrical connections, spliced conductors should be turned upward and pushed

carefully up into outlet box. The wires should be spread apart with the grounded conductor and the

equipment - grounding conductor on one side of the outlet box and the " HOT " wires on the other side.

7]. Electrical diagrams are for reference only. Light kits that are not packed with the fan must be UL/ETL listed

and should be installed per the light kit's installation instructions.

8]. After fan is completely installed, check to make sure that all connections are secure to prevent fan

from falling and/or causing damage or injury.

9]. The fan can be made to work immediately after installation. The bearings are adequately charged with grease,

so that under normal conditions, further lubrication should not be necessary.

10]. The fan must be turned off and stopped before reversing fan direction.

11]. The fan is for downrod mount only.

12] .This fan is reversible.

13]. This fan is controlled by remote.

14]. This fan is suitable for damp location use.