Installation Guide

Attention: See "Special note" on Pg.8 and Pg.9 if you plan to install MULTIPLE
FANS WITH DIFFERENT FREQUENCY CODES.
P7
SET
Press the button “SET” for 3-5 seconds till the fan starts reverse operation (clockwise).
Install battery cover on transmitter.
This fan is doing setting now and will do the following steps to complete its setting automatically.
Reverse operation (clockwise) for about 2.5 minutes
Stop
Forward operation (anti-clockwise) for about 2.5 minutes
Stop
Total 5 minutes for its setting, this fan has completed setting successfully!
IMPORTANT:
In event of no operating, do the following step for re-setting:
Switch off the main power and wait for 10 seconds, then switch
on the power again and do the above setting again.
7C. SETTING before starting fan
7D. TRANSMITTER BUTTON
Light switch (two options)
1. On/Off only
2. Dimming/On/Off
Fan ON/OFF switch:
Reversing function
VII
II
III IV
V
(Lowest Speed)
(Highest Speed)
6 speeds from I (Lowest Speed)
to VI (Highest Speed).
Your fan is ready for operation.