Instructions / Assembly

ManualsBrandsTroposAir ManualsCeiling FansModernaire 52 in. Pure White Ceiling Fan and Light

Owner’s Manual

WARNING : Read and follow these instructions carefully and be mindful of all warnings shown throughout.

3RO52+LK902

Modernaire

This instruction contains 6 pages:

Page 1: Foreword

Page 2: Unpack and inspect parts contained

Page 3: Notes before installation

Page 3~4:

Page 5: Blade installation and

Hanging system installation

Wire connection and Canopy installation

Light kit installation

Page 6: Remote

Toll Free: 1-855-676-7247

6.7 KGS.

14.76 LBS.

Net weight

Summary of content (7 pages)

PAGE 1
Owner’s Manual Modernaire 3RO52+LK902 This instruction contains 6 pages: Page 1: Foreword Page 2: Unpack and inspect parts contained Page 3: Notes before installation Hanging system installation Page 3~4: Wire connection and Canopy installation Page 5: Blade installation and Light kit installation Page 6: Remote Net weight 6.7 KGS. Toll Free: 1-855-676-7247 14.76 LBS. WARNING : Read and follow these instructions carefully and be mindful of all warnings shown throughout.
PAGE 2
READ AND SAVE THESE INSTRUCTIONS WARNING : TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, PLEASE OBSERVE THE FOLLOWING : 1 ] . To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before beginning. Two people recommended for fan installation. 2]. To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring.
PAGE 3
Unpack and inspect fan carefully to be certain all contents are included.
PAGE 4
WARNING: blades should be at least 7 feet from floor Note 1: Note 2: Turn off power at breaker box to avoid possible electrical shock. Use metal outlet box suitable for fan support. Outlet box must support 35 lbs min. OFF OFF OFF 1. HANGING SYSTEM INSTALLATION 1A. Installing mounting plate to ceiling outlet box Install mounting plate to outlet box in ceiling by using screws included with the outlet box and washers from the hardware bag. Mounting Plate 2. WIRE CONNECTION 2A.
PAGE 5
2B. Setting code switches for transmitter Remote controls are tuned to operate together using 4 switches for 16 possible code combinations. 1.Setting the code on the TRANSMITTER 1 Remove battery cover. 2 Slide code switch randomly using a small screwdriver or ball point pen to slide each switch firmly up or down. 3 Install 9V DC battery.(Included) 4 Install battery cover on transmitter. 2.
PAGE 6
4. BLADE INSTALLATION 1 Remove 3 pcs of motor stoppers. 2 Attach blade to blade arm with screws and screw nuts provided from hardware bag. Make sure that all Screws are firmly tightened. 3 Attach the blade assembly to motor by attaching motor screws on b lade holder . NOTE: Do not bend blade or blade arm to prevent wobble. 2 Screw (3) Blade arm Blade Blade Assembly Motor 1 Motor stopper Screw nut (3) 3 Motor screw (2) 5. LIGHT KIT INSTALLATION 5A.
PAGE 7
6. REMOTE NOTE： Make sure transmitter and receiver have the same code for fan operation. LOW:Fan low speed MED:Fan middle speed HI:Fan high speed MED HI LO W O FF OFF: For SETTING / Fan speed : Button for ON/OFF Light 7. Turn on the power - your fan is ready for operation.