Installation Guide

6. CANOPY INSTALLATION

Note: Two screws are installed on mounting

bracket for canopy installation.

6-1. Push up canopy until two pre-installed screws

on mounting bracket are engaged with two key

holes on canopy.

6-2. Rotate canopy slightly until two pre-installed

screws heads are engaged in the narrow end of key

holes.

6-3.Tighten both screws.

6-4. Push deco ring up to canopy, align holes on

canopy with ribs on deco ring, and push “snap-in”.

DIMMER< >ON

12V

DIMMER< >ON

7.REMOTE TRANSMITTER ASSEMBLY

DIMMER<

>ON

7-1. Install the battery

Remove the back cover and install the

12V battery. (Included from remote box)

7-2. Check the dip switch position

(Original dip switch is on Dimming position)

Set dip switch in DIMMER position for LED dimming.

Set dip switch in ON position for LED ON/OFF only.

7-3. Re-install the back cover.

12V

Turn on power at breaker box, the fan is ready for operation!

(The receiver will have beep sound)

Back Cover

Align Holes

6-4. Deco Ring

6-2. Key Hole (2)

6-1. Canopy

Screw (2)

Canopy