Instructions / Assembly

ManualsBrandsTroposAir ManualsCeiling FansSt. Augustine 59 in. Indoor/Outdoor Oil Rubbed Bronze Ceiling Fan with Light

Owner’s ManualOwner’s Manual

St. Augustine

Toll Free 1-855-676-7247

WARNING: Read and follow these instructions carefully and be mindful of all warnings shown throughout.

Net Weight

8.46 KGS

18.6 LBS

These instructions contain 4 pages:

Page 1: Foreword

Page 2: Unpack and inspect parts contained, and pre-installation notes

Page 3: Light /Cover Installation

Page 4: Hanging system installation

Page 5: Wiring connections, Canopy and Blade installation and Remote Setting

Model No:

59DFG-L

HS-1233-F

Summary of content (6 pages)

PAGE 1
Owner’s Manual St. Augustine Model No: 59DFG-L HS-1233-F These instructions contain 4 pages: Page 1: Foreword Page 2: Unpack and inspect parts contained, and pre-installation notes Page 3: Light /Cover Installation Page 4: Hanging system installation Page 5: Wiring connections, Canopy and Blade installation and Remote Setting Net Weight 8.46 KGS 18.6 LBS Toll Free 1-855-676-7247 WARNING: Read and follow these instructions carefully and be mindful of all warnings shown throughout.
PAGE 2
READ AND SAVE THESE INSTRUCTIONS WARNING : TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, PLEASE OBSERVE THE FOLLOWING: 1.] To ensure success of installation, be sure read these instructions and review the diagrams thoroughly before beginning. 2.] To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring. All electrical connections must be made in accordance with local codes, ordinances and/or the National Electrical Code.
PAGE 3
Unpack and inspect fan carefully to be certain all contents are included.
PAGE 4
1. LIGHT/COVER INSTALLATION Hint: Lay the motor assembly on the styrofoam packing with the light wires up, 1A. Installing the Light Pan Note: Three screws are pre-installed on motor assembly for light pan installation. You will need to remove one and loosen two of these screws. After feeding the light wires through the center hole, lower the Light Pan onto motor assembly aligning the two loosened screws with the large end of the key holes.
PAGE 5
2. HANGING SYSTEM INSTALLATION 2A. Installing mounting bracket to ceiling outlet box Install mounting bracket to outlet box in ceiling by using screws included with the outlet box and washers from the hardware bag. Outlet Box Mounting Bracket 2B. Installing Downrod and Yoke Remove cross pin, washer and cotter pin from downrod. Insert downrod through canopy and yoke cover, and feed motor wires through downrod. Loosen 2 downrod jam screws at yoke. Insert downrod assembly into yoke.
PAGE 6
3. WIRING CONNECTION 3A. Insert receiver into mounting bracket Note: Do not squeeze all the wires while inserting the receiver into the mounting bracket. Receiver Mounting Bracket 3B. Making electrical wire connections Follow separate instructions enclosed with the remote control. 4. CANOPY INSTALLATION 4. Installing the canopy Note: Two screws are pre-installed on mounting bracket for canopy installation. You will need to remove one and loosen the other slightly.