Instructions / Assembly

Plug In
Connectors
Light
Socket
Fixture
Screws for
Light Socket
(4)
1. LIGHT/COVER INSTALLATION
Align three holes in light grill with
three holes in motor assembly.
Lower light grill into position.
Secure light grill to motor assembly
using three (3) screws for light cover.
1C. Installing the Light Grill
Align
Key Holes
Rotate
Light
Pan
Install Screw
and tighten
1B. Installing the Light Fixture
Install the bulb
into the socket.
Plug in wire connectors, matching wire colors.
Secure light socket fixture to motor assembly
using four (4) screws for light socket fixture.
Install Bulb
Note: Four screws are pre-installed on Light Pan for light
socket fixture installation. You will need to remove these screws.
Screws for
Light Grill (3)
Lower
Light Grill
Align Holes
After feeding the light wires through the center hole, lower
the Light Pan onto motor assembly aligning the two loosened
screws with the large end of the key holes.
Rotate Light Pan slightly so that screws are engaged in narrow
end of key holes.
Install the screw remove earlier and tighten all three screws.
Note: Three screws are pre-installed on motor assembly for light
pan installation. You will need to remove one and loosen two of
these screws.
1A. Installing the Light Pan
Hint: Lay the motor assembly on the styrofoam packing with the light wires up,