B 400 EN TRT-BA-B400-TC2014-02-003-EN OPERATING MANUAL HUMIDIFIER
You can download the current version of the operating manual and the EU declaration of conformity via the following link: Table of contents Notes regarding the operating manual................................. 2 Safety ..................................................................................... 2 Information about the device................................................ 4 B 400 Transport and storage........................................................... 5 Assembly and installation.........
• • • • • • • • • • • • • Check whether the device is switched off and all installation instructions have been observed, before connecting the power cable to a properly grounded socket. Observe the device's power input, cable length and intended use when selecting extensions to the power cable. Completely unroll extension cables. Avoid electrical overload. Before carrying out maintenance, care or repair work on the device, remove the mains plug from the mains socket.
FAN Behaviour in the event of an emergency SPEED STAT HYGRO 1 0 2 ier Air Humidif 1. Switch off the device. 2. In an emergency, disconnect the device from the mains feed-in: Hold onto the mains plug while pulling the power cable out of the mains socket. 3. Do not reconnect a defective device to the mains.
Transport and storage Assembly and installation Note If you store or transport the device improperly, the device may be damaged. Note the information regarding transport and storage of the device. Transport To make the device easier to transport, it is fitted with wheels. Before transporting the device, observe the following: • Switch off the device. • Hold onto the mains plug while pulling the power cable out of the mains socket. • Do not use the power cable to drag the device. • Empty the water tank.
• Do not create tripping hazards when laying the power cable or other electric cables, especially when positioning the device in the middle of the room. Use cable bridges. Make sure that extension cables are unrolled completely. If possible, set the device up in the middle of a room to ensure optimum performance. A heat source near the device encourages its output. Do not set up the humidifier next to furniture, paintings and other devices which can be damaged by humidity.
4. Close the flap for the water funnel (8). 5. Make sure the float inside the water tank is not jammed and can float freely. 6. Make sure that the device is neither damp nor wet on the outside. Otherwise wipe it dry. Operation • Avoid open doors and windows. Operating element 2 1 3 0 2 Inserting the cover grilles 1. Insert the cover grilles for reasons of safety and to provide an individual air outlet. 1 4 Air Humidifi er 1 0 2 HYGRO STAT FAN SPEED No.
Shutdown Warning of electrical voltage Do not touch the mains plug with wet or damp hands. Switch off the device. Hold onto the mains plug while pulling the power cable out of the mains socket. Empty the water tank. Use a cloth to wipe all parts of the device dry. Clean the device according to the Maintenance chapter. Store the device according to the Storage chapter. • • • • • • Available accessories Warning Only use accessories and additional equipment specified in the operating manual.
Maintenance intervals Maintenance Maintenance and care interval before every start-up X X Clean housing and water tank X Visually check the inside of the device for dirt X Check air inlet grid, cover grille and evaporation mats for dirt and foreign objects and clean or replace if necessary at least every at least every at least every at least 2 weeks 4 weeks 6 months annually X Fill the water tank Check air inlets and outlets for dirt and foreign objects and clean if necessary as needed X X X
Maintenance and care log Device number: .................................... Device type: .............................................
Cleaning the water tank Activities required before starting maintenance • • Warning of electrical voltage Do not touch the mains plug with wet or damp hands. Switch the device off. Hold onto the mains plug while pulling the power cable out of the mains socket. The water tank should be cleaned at least once a year. Before a longer period of non-use or storage the water tank should be drained. 1. Remove the cover grilles at the air outlet.
3. Remove the water tank from the device. Make sure not to damage the float when removing the water tank. 10. Reinsert the drum and evaporation mats in the device (see chapter Inserting the drum). FAN SPEED STAT HYGRO 1 0 2 er Air Humidifi Air Humidifier 1 0 2 HYGROST AT FAN 4. 5. 6. 7. 8. Thoroughly rinse the water tank in a sink or similar. Clean the tank using a mild cleaning agent (no detergent!). Remove all calcium deposits in the water tank.
Cleaning the device interior and evaporation mats Warning Make sure that the evaporation mats are neither worn nor damaged. The evaporation mats' edges must not be torn or misshaped. Before reinserting the evaporation mats, ensure that these are undamaged! Observe the chapter Maintenance intervals and replace the evaporation mats in due time! 1. Remove the cover grilles at the air outlet. 4. Remove the evaporation mat from the drum's lateral surface. 5.
10. Fit the cover grilles onto the air outlet (see chapter Inserting the cover grilles). 7. Reattach the round evaporation mat to the drum. Air Humidifi er 0 2 1 HYGRO STAT FAN SPEED 8. Refit the evaporation mat to the drum's lateral surface. Activities required after maintenance If you want to continue using the device: • Reconnect the device to the mains. If you do not intend to use the device for a considerable time: • Store the device according to the Storage chapter. 9.
Technical annex Disposal Technical data Parameter Value Model B 400 Max.
Trotec GmbH & Co. KG Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.
