Operation Manual

9 EN
Operating manual – humidifier B 6 E
Setting the timer
For the device to switch off automatically after a predefined
number of hours (up to max. 12h) you can programme the
timer.
The timer can be programmed in increments of 1hour (1 to
12h) in manual humidification mode and automatic mode.
Please proceed as follows to programme automatic switch-off:
1. Press the Timer button(25).
ð The number of hours flashes on the segment
display(15).
2. Press the Timer button(25) until the desired number of
hours is displayed.
3. Wait a moment until the number of hours stops flashing.
ð The timer setting equals the desired number of hours.
ð The current room humidity is displayed again.
ð The device switches off after the set period of time.
Note regarding automatic switch-off:
• Pressing the On/Off button(26) deactivates the automatic
switch-off function.
• The timer stops when the lacking water indication(17)
lights up. The timer continues to run as soon as the water
tank is full again.
Switching ionization on or off
Ionization can be switched on as needed. The device will then
release ions for additional air purification. The released ions
remove pollen, dust, viruses and bacteria from the room air.
Ionization can be switched on in any operating mode.
1. Press the Timer button(25) for approx. 5 s to switch
ionization on or off.
ð When ionization is activated, the anion indication(20)
will be shown on the display.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
• Switch off the device.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Empty the water tank.
• Empty the lower part.
• Use a cloth to wipe all parts of the device dry.
• Clean the device according to the Maintenance chapter.
• Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation Article number
SecoSan
®
Stick10 6.100.004.110
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
• Check the power connection.
• Check the power cable and mains plug for damages.
• Check the on-site fusing.
• Check whether the water tank indicator light is illuminated.
The water tank might be empty and need refilling.
• Wait for 10minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device is running, but there is no formation of mist:
• Check whether the water tank indicator light is illuminated.
The water tank might be empty and need refilling.
• Check the valve in the water tank lid. The valve must be
able to move freely. If necessary, clean the water tank.
• Check the float in the lower part of the device. The float
should be able to move freely.
• Check the air filter for dirt. If necessary, clean the air filter.
• Check the nebulizer intensity setting and increase it if
required.
• Check the nebulizer membrane in the lower part of the
device for dirt and clean it if required.
The water tank is full, but the device indicates an empty
water tank:
• Heavy deposits on the filter cartridge may prevent the
water from flowing from the water tank into the device.
This can occur if the device has been out of use for a long
time. Rinse the filter cartridge with clear water and, if
required, carefully clean the filter at the filter cartridge.
• Check the valve in the water tank lid. The valve must be
able to move freely. If necessary, clean the water tank.