Operation Manual
11 EN
Operating manual – humidifier B 6 E
3. Turn the water tank over.
4. Unscrew the fuel tank cap(13).
13
6
5. Drain the residual water from the water tank.
6. Take the SecoSan
®
Stick out of the water tank.
7. Thoroughly rinse the water tank with a conventional
descaling agent (e.g. household vinegar).
8. Thoroughly rinse the water tank and the SecoSan
®
Stick
with clear water.
9. Allow the water tank to dry.
10. Clean the inside of the bottom section and the mist nozzle
with a conventional descaling agent (e.g.household
vinegar) and then use a lint-free cloth to wipe the parts
dry.
For cleaning the nebulizer membrane, see chapter
Cleaning the nebulizer membrane.
11. Insert the SecoSan
®
Stick into the water tank.
12. Fill the water tank with fresh drinking water.
13. If required, screw the filter cartridge with water
softener(6) onto the lid(13).
14. Screw the tank lid(13) firmly back onto the water tank(2).
6
13
15. Refit the water tank(2) into the device.
ð When doing so, make sure that the water tank is
correctly inserted in the guide.
ð Please note that after inserting the water tank, the
water immediately starts to run into the bottom of the
device.
16. Refit the mist nozzle(1) onto the water tank(2).