Operation Manual

5 EN
Operating manual – humidifier B 6 E
Filling the water tank
The water tank should be filled before first use or when the
lacking water indication(16) lights up.
Notice
Fill the device with fresh drinking water only. The
water temperature must not exceed 40°C.
Scented oil or other additives can damage the plastics
and the nebulizer membrane.
Info
If possible, change the water on a daily basis to
prevent bacterial growth.
1. Remove the mist nozzle(1) from the water tank.
2. Remove the water tank(2) from the device by lifting the
water tank at the transport handle(4).
Note that there may still be residual water left in the lower
part(3) if the device was used beforehand.
3
2
1
4
3. Turn the water tank over. Please note that the opening at
the transport handle must not be used to fill the tank! It is
the outlet for the water mist.
4. Unscrew the fuel tank cap(13).
13
6
5. Fill fresh drinking water (approx. 5l, maximally 40°C) into
the water tank.
6. Insert the SecoSan
®
Stick (optional accessory) into the
water tank.
7. Screw the tank lid(13) firmly back onto the water tank(2).
6
13
8. Refit the water tank(2) into the device.
ð When doing so, make sure that the water tank is
correctly inserted in the guide.
ð Please note that after inserting the water tank, the
water immediately starts to run into the bottom of the
device.
9. Refit the mist nozzle(1) onto the water tank(2).