Operation Manual

2 Operating manual – Condenser dryer DH 30/60 AX EN

Description of the device

This device uses the principle of condensation to automatically

dehumidify rooms.

The fan sucks damp room air through the air inlet (3), the evapo-

rator and to the condenser located behind it. The air is cooled at

the cold evaporator until it is below the dew point. Water vapour

contained in the room air precipitates on the evaporator fins as

either condensation or frost. The dehumidified, cooled air is

rewarmed at the condenser and blown out at a temperature of

approx. 5 °C above room temperature. The drier air, thus condi-

tioned, mixes with the air in the room via the air outlet (1). The

humidity in the room where the device is positioned is reduced as

air constantly circulates through the device. Depending on the air

temperature and the relative humidity, the condensed water either

drops continuously or only during the defrost phase into the con-

densation tray. The condensate is discharged from the device via

a pre-assembled condensation drain hose (4).

To set the desired humidity level, a hygrostat with control dial (5)

is provided in the device's interior. This control dial can be easily

accessed once the protective housing (2) has been removed.

The device can reduce the relative humidity of a room by up to

approx. 30 %. Because of the heat radiation which is tied up in

operation, the room temperature can rise by approx. 1-3 °C.

Device depiction

Scope of delivery

• Condenser dryer DH 30/60 AX

•Wall holder

• Condensation drain hose

• Operating manual

• Screws and universal dowels (size 6 mm)

Information about the device

No. Operating element

1 Air outlet

2 Protective housing

3 Air inlet

4 Hose connector for condensation drain hose (inside the device)

5 Control dial hygrostat (inside the device)

6 Wall holder