DH 30/60 AX TRT-BA-DH 30/60-TC-001-EN EN Operating Manual – Condenser dryer DH 30/60 AX TROTEC® GmbH & Co. KG • Grebbener Straße 7 • D-52525 Heinsberg Tel.: +49 2452 962-400 • Fax: +49 2452 962-200 www.trotec.com • E-Mail: info@trotec.
Table of contents Notes regarding the operating manual Notes regarding the operating manual .................................... 01 Symbols Information about the device................................................... 02 Hazardous electric current! Safety ..................................................................................... 05 Warns about hazards from electric current which can Transport, assembly and preparation for start-up.................... 06 lead to injuries or even death.
Information about the device Device depiction Description of the device This device uses the principle of condensation to automatically dehumidify rooms. The fan sucks damp room air through the air inlet (3), the evaporator and to the condenser located behind it. The air is cooled at the cold evaporator until it is below the dew point. Water vapour contained in the room air precipitates on the evaporator fins as either condensation or frost.
Technical data Parameter Value Model Dehumidifying capacity, max. Operating temperature Operating range for relative humidity Air flow rate, max. Electric connection Power input Fuse (home) Cooling agent Amount of cooling agent Weight Dimensions (HxDxW) Minimum distance from walls of other objects DH 30 AX 45 l / 24 h 0-40 °C 30-90 % 700 m³/h 230 V / 50 Hz 750 W 16 A R407c 0.
Operating manual – Condenser dryer DH 30/60 AX BR V DEHUMIDI STAT SH RELAY SD219250 WAS SD154650 'SCHRAK' & 'FINDER' DELETED FROM RELAY R E L AY C H A NG E D V A R I O U S W I R E C O L O U R S C H G 'D 7 6 DRAWING CHANGE AND LPHW DETAIL ADDED R E L AY NO T E C H A NG E D 8 ISS 962 9 C/N 946 955 955 1056 B U T T S U S E D O N T T W 55 O N L Y H A R D K IC K C A P AD D E D 10 GSM GS M GSM APPD 24:07:07 DATE 2 8: 07: 97 18: 05: 98 2 9: 0 6 : 9 6 0 5: 11: 98 2 5: 09: 03 2 4:
Intended use Only use the device DH 30/60 AX as a stationary industrial dryer Read this manual carefully before starting or using the for drying and dehumidifying room air, while adhering to and following the technical data. device. Store the manual near the device or its site of use! Safety Intended use encapsulates: • Do not use the device in potentially explosive rooms.
Danger! A falling device can cause injuries! Always utilize the help of another person to transport and assemble the device. Never stand below the device when suspended in the air. Ensure adequate stability of the device's wall fixing. Assemble the device as follows: Check the condensation drain hose for proper fit and adjust the hygrostat to the desired humidity level, before you put the protective housing back on the device. Only have an electrically skilled person connect the power cable! A.
D. G. E. H. F.
Storage Operating elements When out of use, store the device as follows: • dry, • with a roof overhead, • in an upright position where it is protected from dust and direct sunlight, • with a plastic cover to protect it from invasive dust, if necessary. • The storage temperature is the same as the range given for the operating temperature in the chapter Technical Data. Operation • After being switched on, the device operates fully automati5 cally.
Positioning the condensation drain hose Switch device on Note: 1. Ensure that the condensation drain hose has been laid and connected properly. Do not create tripping hazards. The condensation drain hose is already installed when the device is delivered. 2. Ensure that the condensation drain hose is not bent or jammed and that there are no objects on the condensation 1. Ensure that the condensation drain hose is properly connectdrain hose. ed to the device and is free of damage. 2.
The device gets very warm, is loud or is losing performance: • Check the air inlets and air filter are not dirty. Remove external The accurate functionality of the device was tested during producdirt. tion a number of times. However, if functionality faults do occur, • Check the inside of the device for dirt (see chapter Maintethen check the device according to the following list. nance). If necessary, clean the interior of the device using compressed air.
Maintenance Maintenance intervals Maintenance and care interval before every start Empty the condensate pump, condensation tray and/or condenser dryer check air inlets and outlets for dirt and foreign objects and clean if necessary clean housing visually check the inside of the device for dirt check air inlet grid and air filter for dirt and foreign objects and clean or replace if necessary replace air filter check for damages check attachment screws carry out a test run when neces- at least every at lea
Activities for before the start of maintenance Cleaning the housing and air inlets 1. Do not touch the power cable with wet or damp hands. 1. Use a soft, lint-free cloth for cleaning. 2. Prior to any work, have an electrically skilled person discon- 2. Dampen the cloth with clean water. Do not use sprays, solnect the power cable! vents, alcohol-based or abrasive cleaners to dampen the cloth.
Overview of spare parts and spare parts list – DH 30 AX/AXP 26 36 37 38 39 2 6 58 57 30 i 14 3 7 35 5 34 31 GAS CHARGE 4 28 29 Note! The position numbers of the spare parts differ from those describing the positions of other parts mentioned in this operating manual. No. Spare part No.
Overview of spare parts and spare parts list – DH 30 AX – electrical equipment ON MAKE TIMER No. Spare part No. Spare part 2 4 5 6 7 8 9 control knob gasket humidistat defrost stat fan cap (2 μF) relay (c/o 2-pole 25 A 230 V AC coil) timer 10 11 12 13 14 15 16 run cap (15 μF) 5-way terminal block (15 A) loom assembly rocker switch cover transformer (12 V) relay (25 A c/o 12 V) 14 Operating manual – Condenser dryer DH 30/60 AX 6 11 4 14 13 8 7 2 0.
Overview of spare parts and spare parts list – DH 30 AXP – electrical equipment ON MAKE TIMER No. Spare part No. Spare part 2 4 5 6 7 8 9 control knob gasket humidistat timer defrost stat fan cap (2 μF) relay (c/o 2-pole 25 A 230 V AC coil) timer 10 11 12 13 14 15 16 run cap (15 μF) 6-way terminal block loom assembly rocker switch cover transformer (12 V) relay (25 A c/o 12 V) EN Operating manual – Condenser dryer DH 30/60 AX 6 11 4 14 13 8 7 2 0.
8 40 41 65 A1 No. Spare part No. Spare part 2 3 5 6 7 8 15 30 31 32 33 evaporator / condenser assembly compressor herm (AJ5512C) fan assembly drip tray (evaporator; for Murprotec versions fit) electrical box assembly drip tray (compressor) Schrader valve user manual refrigerant (R407c) solenoid valve solenoid coil (240 V) 37 38 40 41 42 43 57 58 switch high pressure (ACB-DB64) LP switch (LCB-DA15) evaporator condenser drier capillary tube (0.
6 GAS CHARGE AT 130 PSI-G 30 51 28 i 48 57 39 41 5 2 40 39 40 27 31 8 14 29 4 BLUE SEAL (COMPRESSOR) (HEATERS) HP SWITCH --- 400 psi 47 HP SWITCH ---300 psi PINK SEAL 7 Note! The position numbers of the spare parts differ from those describing the positions of other parts mentioned in this operating manual. 58 Overview of spare parts and spare parts list – DH 60 AXP No. Spare part No.
Overview of spare parts and spare parts list – DH 60 AX/AXP – electrical equipment 10 3 5 9 No. Spare part No.
Disposal Declaration of conformity In the European Union, electronic equipment must not be treated as domestic waste, but must be disposed of professionally in accordance with Directive 2002/96/EC of the European Parliament and Council of 27th January 2003 concerning old electrical and electronic equipment. At the end of its life, please dispose of this instrument in a manner appropriate to the relevant legal requirements.
TROTEC® GmbH & Co. KG • Grebbener Straße 7 • D-52525 Heinsberg Tel.: +49 2452 962-400 • Fax: +49 2452 962-200 www.trotec.com • E-Mail: info@trotec.
