Operation Manual

10 EN
local air conditioner PAC 2100 X / PAC 2600 X
Setting the operating mode
Cooling
In cooling mode the room will be cooled down to the desired
target temperature.
1. Press the MODE button(12) until the Cool LED(14) is
illuminated.
ð Cooling mode is selected.
2. Select the desired target temperature by use of the
Plus(16) or Minus(13) buttons. Temperatures between
17°C and 30°C can be selected.
ð The currently selected target temperature is shown on
the segment display(15).
3. The fan stage can be adjusted via the remote control:
Press the FAN button(25) to set the desired fan stage.
ð The fan stage is shown in the FAN indication(34).
Dehumidification
In dehumidification mode the humidity level in the room is
reduced.
The temperature cannot be adjusted and the fan runs at the
lowest speed level.
Info
Remove the exhaust air hose during dehumidification,
otherwise the performance will be insufficient.
1. Press the MODE button(12) until the Dry LED(14) is
illuminated.
ð Dehumidification mode is selected.
Info
If the device is operated in a very humid environment,
the accumulating condensate must be discharged at
regular intervals (see chapter Condensate discharge).
Connecting the condensation drain hose
If you use the device for an extended period of time or you don't
want to empty the tank all the time, you can connect a
condensation drain hose to the hose connection.
ü The device is switched off.
ü The device is disconnected from the mains.
1. Carefully transport or wheel the device to a suitable
location for discharging the condensate (e.g. a drain) or
position a suitable collection container under the
condensate outlet.
2. Unscrew the sealing cap counter-clockwise from the hose
connection(9).
3. Remove the rubber stopper from the hose connection.
4. Keep sealing cap and rubber stopper for later use.
5. Connect the condensation drain hose to the hose
connection(9).