Operation Manual

EN 13
local air conditioner PAC 2100 X / PAC 2600 X
Setting the timer
The timer has two modes of operation:
• automatic switch-on upon expiry of a preset number of
hours
• automatic switch-off upon expiry of a preset number of
hours
The timer can be programmed in increments of 0.5hours
(0 to 10h) or in increments of 1hour (10 to 24h).
This setting can only be made using the remote control.
The function can be set in all operating modes. It can be
activated both during operation and in standby mode.
Automatic switch-on and automatic switch-off may be enabled
at the same time. If so, Timer On and Timer Off will both be
displayed simultaneously.
Note
Do not leave the operating device unattended in a
freely accessible room with an activated timer.
Automatic switch-on
ü The device is switched off.
1. Press the TIMER ON button(21) to activate the timer.
2. Hold or repeatedly press the TIMER ON button(21) to
select the desired number of hours until automatic
switch-on.
3. Wait for 3seconds to confirm the setting.
ð The number of hours until automatic switch-on will be
indicated for approx. 3s both on the display(19) and
the segment display(15).
ð The Timer On setting will also be indicated on the
display(19).
ð A dot will be indicated in the bottom right corner of the
segment display(15).
ð After the predefined time, the device switches itself on.
Notes regarding automatic switch-on:
• If the device is disconnected from the power supply, all
settings for automatic switch-on are deleted.
• Manually switching the device on disables the automatic
switch-on function.
• If you select 0hours, the timer will be off.
Automatic switch-off
ü The device is switched on.
1. Press the TIMER OFF button(22) to activate the timer.
2. Hold or repeatedly press the TIMER OFF button(22) to
select the desired number of hours until automatic
switch-off.
3. Wait for 3seconds to confirm the setting.
ð The number of hours until automatic switch-on will be
indicated for approx. 3s both on the display(19) and
the segment display(15).
ð The Timer Off setting will also be indicated on the
display(19).
ð A dot will be indicated in the bottom right corner of the
segment display(15).
ð After the predefined time, the device switches itself off.
Automatic operation
During automatic operation cooling and ventilation are regulated
depending on the ambient and target temperature.
This setting can only be made using the remote control.
1. Use the MODE button(27) to select Auto mode.
ð Auto mode is displayed in the operating mode
indication(35).
Night mode
Night mode can be activated in cooling mode and during
automatic operation.
This setting can only be made using the remote control.
Night mode comes with the following settings:
• After 30minutes the preset temperature is increased by
1°C. After 1hour the preset temperature will again be
increased by 1°C. Then the temperature is kept constant
for 7hours.
Subsequently, the device switches back to the preset
temperature from before night mode.
• Ventilation is preset to the automatic stage and cannot be
adjusted.
To activate night mode, please proceed as follows:
1. Select cooling mode or automatic operation.
2. Press the SLEEP button(24).
ð Both the night mode and the automatic stage will be
indicated on the display(19).
3. In order to switch the night mode off, press the
SLEEP button(24) once again.
ð The night mode indication(32) disappears.
ð The automatic stage remains unaffected.