Operation Manual

EN 7

air cooler PAE 25

1. Remove the water tank(8) from the device.

ð When removing the water tank quickly, the mechanism

for lowering the pump may be released. Push the pump

back up into the housing (see chapter Errors and faults).

2. Fill the water tank(8) with fresh drinking water only.

Optionally, you can add ice cubes made of drinking water

for additional cooling.

ð Observe the minimum(13) and maximum filling

level(12) at the filling level indicator.

The water tank must be filled up to minimum filling

level(13) to enable pump operation.

3. If required, put the two ice packs into the compartment

inside the water tank to achieve an enhanced cooling

effect.

4. Refit the water tank into the device.

5. Make sure that the device is neither damp nor wet on the

outside. Otherwise wipe it dry.

Inserting honeycomb filter and air filter

Note

When set to air cooling mode, the device should not be

operated without the honeycomb filter, otherwise

cooling will not work.

Note

Do not operate the device without an inserted air filter!

Without the air filter, the inside of the device will be

heavily contaminated. This could reduce the

performance and result in damage to the device.

• Make sure that both the honeycomb and the air filter are

installed before switching the device on.

Opening the ventilation flaps

Prior to switching the device on, open the two segments of the

ventilation flaps at the air outlet.

Connecting the power cable

• Insert the mains plug into a properly secured mains

socket.

• The symbols on the control panel display light up briefly.

The device is now in standby mode.