TTK 140/170/350/650 S TRT-BA-TTK 140/170/350/650 S_2013-TC-001-EN EN Operating Manual – Dehumidifier (2013 models) TROTEC® GmbH & Co. KG • Grebbener Straße 7 • D-52525 Heinsberg Tel.: +49 2452 962-400 • Fax: +49 2452 962-200 www.trotec.com • E-mail: info@trotec.
Legal notice Table of contents Notes regarding the operating manual .................. Information about the device ................................ Safety................................................................... Transport.............................................................. Operation ............................................................. Errors and faults ................................................... Maintenance.........................................................
Information about the device Models The TTK-S series (2013 models) comprises the following devices: TTK 650 S TTK 140 S TTK 170/350 S Note! For simplification purposes the figures used in this documentation only depict one device, which can deviate from the actual version. The factual information content remains unaffected. If necessary in case of relevant differences the respective devices will be shown.
Description of the device Device depiction This device uses the principle of condensation to automatically dehumidify rooms. The fan sucks damp room air through the air inlet, the air filter (1), the evaporator and to the condenser located behind it. The air is cooled at the cold evaporator until it is below the dew point. Water vapour contained in the room air precipitates on the evaporator fins as either condensation or frost.
Technical data Parameter Value Dehumidifying capacity, max. Operating temperature Operating range for relative humidity Amount of air Input voltage Power input, max. Fuse (home) Condensation tank TTK 140 S TTK 170 S 40 l 50 l TTK 350 S TTK 650 S 70 l 5-32 °C 32-100 % 150 l 580 m³/h 0.7 kW 10 A 6l Type of cooling agent Amount of cooling agent Weight Dimensions without handle (HxDxW) Dimensions with handle (HxDxW) Minimum distance from walls of other objects 1000 m³/h 230 V / 50 Hz 1.
Circuit diagram (TTK 650 S) Wiring diagram with Time Counter (Optional) Wiring diagram with Time & Energy Counter (Optional) E L E L S1 0/1 E S1 0/1 E S2 S2 230V/50Hz 230V/50Hz Schuko Plug Schuko Plug R Time Counter (Optional) HE PCB H L R L NC NO N Lin N Lout Time + Energy Counter (Optional) RC M1 M2 PCB N L NC NO M1 Y N N RC M2 Y N E L N S1 S2 M1 M2 Y R RC H - Earthing / Erdung - Line / Außenleiter - Common Line / Gemeinsame - On-Off switch / Geräteschalter 0/1 - Humi
Intended use encapsulates: • drying and dehumidifying: Safety Read this manual carefully before starting or using the device. Store the manual near the device or its site of use! • Do not use the device in potentially explosive rooms. • Do not use the device in atmospheres containing oil, sulphur, chlorine or salt. • Set the device in an upright and stable position.
Caution! To avoid damages to the device, never operate the device without an air filter inserted! Danger! Dangers can occur at the device when it is used by untrained people in an unprofessional or improper way! Observe the personnel qualifications! Note! After unpacking the device, the two lower screws must be unscrewed and the transport handle remounted using only one screw (i.e. one screw remains). A. Behaviour in the event of an emergency 1. Disconnect the device from the mains power in an emergency.
5. Hold the transport handle in both hands and tilt the device so that it can be rolled on its wheels. 6. Move the device to the site where you want to use it. 7. The following only applies to the TTK 140 S: Move the device to the application site by use of wheels and lateral carry handles. Operation • After being switched on, the device operates fully automatically until the condensation tank is full and the device switches itself off (switch-off only with TTK 140 S, TTK 170 S and TTK 350 S).
Notes regarding the dehumidification performance Dehumidification performance depends on: • the spatial composition of the room • the room temperature • the relative humidity The higher the room temperature and relative humidity, the higher the dehumidification performance. For using in living rooms, a relative humidity of approx. 50-60 % is sufficient. In store rooms and archives, the humidity should not exceed approx. 50 %.
Start procedure Connecting the condensation drain hose Inserting air filter (TTK 650 S) (TTK 140/170/350/650 S) A. B.
Switch device on Continuous operation mode 1. Carry out the following inspections prior to In continuous operation mode, the device dehumidiswitch-on: fies the air constantly, regardless of the humidity in – The following only applies to TTK 140 S, the air. To start continuous operation mode, set the rotary TTK 170 S and TTK 350 S: Ensure that the condensation tank is empty and switch (13) to Max. inserted correctly.
Emptying the condensation tank (TTK 140/170/350 S) A. D. B. C.
Operation with hose attached to the condensation plug (TTK 140/170/350 S) A. C. 1/2″ B. Shut down procedure 1. Switch off the device at the mains switch (see chapter Operating elements). 2. Depending on the model, proceed as follows to remove condensation from the device: – Empty the condensation tank and wipe it dry with a clean cloth. Check for dripping condensation. – Remove the condensation drain hose and any residual fluid from it. 3. Do not touch the mains plug with wet or damp hands. 4.
• From the outside, check the condenser for dirt (see chapter Maintenance). If your condenser is dirty, have it cleaned by a specialist company for cooling and air-conditioning or by TROTEC®. Errors and faults The accurate functionality of the device was tested during production a number of times. However, if functionality faults do occur, then check the device The device is loud or vibrates; condensation leaks: according to the following list.
Maintenance Maintenance intervals empty condensation tank check air inlets and outlets for dirt and foreign objects and clean if necessary clean housing visually check the inside of the device for dirt check air inlet grid and air filter for dirt and foreign objects and clean or replace if necessary replace air filter check for damages check attachment screws carry out a test run at least every 6 months at least every 4 weeks at least when necevery 2 essary weeks before every start Maintenance and car
Activities for before the start of maintenance Cleaning the housing and condensation tank 1. Do not touch the mains plug with wet or damp 1. Use a soft, lint-free cloth for cleaning. hands. 2. Dampen the cloth with clean water. Do not use 2. Before any work, detach the mains plug! sprays, solvents, alcohol-based or abrasive cleaners to dampen the cloth.
Cleaning the air inlets and the air filter (TTK 140/170/350/650 S) A. C. D. B. Caution! Ensure that the air filter is not worn or damaged. The corners and edges of the air filter must not be rounded or misshaped.
Overview of spare parts and spare parts list Note! The position numbers of the spare parts differ from those describing the positions of other parts mentioned in this operating manual. 9 39 TTK 140 S 6 4 27 28 26 3 12 35 25 41 40 36 42 5 32 43 1 24 21 23 22 44 8 13 7 19 37 14 2 30 1 31 29 11 20 17 16 10 33 34 No. Spare part No. Spare part No.
Overview of spare parts and spare parts list Note! The position numbers of the spare parts differ from those describing the positions of other parts mentioned in this operating manual. 38 9 TTK 170 S 6 4 17 18 16 3 10 48 15 25 47 26 5 22 37 50 14 11 29 51 13 31 8 49 12 7 43 2 39 27 40 1 21 28 20 30 19 44 45 No.
Overview of spare parts and spare parts list Note! The position numbers of the spare parts differ from those describing the positions of other parts mentioned in this operating manual. 38 9 TTK 350 S 6 4 17 18 16 3 10 48 15 25 47 26 5 22 37 50 14 11 29 51 13 31 8 49 12 7 43 2 39 27 40 1 21 28 20 30 19 44 45 No.
Overview of spare parts and spare parts list Note! The position numbers of the spare parts differ from those describing the positions of other parts mentioned in this operating manual. 14 34 6 TTK 650 S 11 4 51 56 57 3 32 30 31 33 44 23 26 10 48 28 17 49 25 58 13 16 42 15 24 9 40 54 41 5 43 35 8 36 21 37 7 2 19 22 18 47 2 46 No. Spare part No. Spare part No.
Disposal Declaration of conformity In the European Union, electronic equipment must not be treated as domestic waste, but must be disposed of professionally in accordance with Directive 2002/96/EC of the European Parliament and Council of 27th January 2003 concerning old electrical and electronic equipment. At the end of its life, please dispose of this device according to the valid legal requirements.
TROTEC® GmbH & Co. KG • Grebbener Straße 7 • D-52525 Heinsberg Tel.: +49 2452 962-400 • Fax: +49 2452 962-200 www.trotec.com • E-mail: info@trotec.