Operation Manual

EN Operating Manual – Construction dryer TTK 400 B - 7
Danger!
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Danger!
A toppling device can cause you injuries! Only slightly tilt
the device and move it carefully. If necessary, ask
another person to help. For longer distances, transport
the device with a fork lift or elevating truck. Never stand
below the device when suspended in the air.
Behaviour in the event of an emergency
1. Disconnect the device from the mains power in an emergency.
2. Do not reconnect a defective device to the mains power.
To make the device easier to transport, it is fitted with wheels and
a bar handle. If necessary, transport the device with the help of
another person. To lift the device, use a fork lift or an elevating
truck.
Before transporting the device, proceed as follows:
1. Switch off the device at the mains switch (see chapter "Oper-
ating elements").
2. Remove the mains plug from the mains socket. Do not use the
power cable to drag the device!
3. Empty the condensation drain hose or the condensation pump
(optional). Check for dripping condensation.
4. Hold the bar handle in both hands and carefully tilt the device.
5. Transport the device on its wheels.
After transporting the device, proceed as follows:
1. Set the device in an upright position after transport.
2. Ensure that both rubber feet lie flat on the floor. The rubber feet
lock the device and prevent it from rolling away.
Adjusting the bar handle
Depending on your requirements, the bar handle can be installed
horizontally or vertically. To adjust the bar handle, carry out the
following steps on both sides of the device:
1. Loosen screw (15).
2. Unscrew screws (16) and (17).
3. Turn the bar handle by 90°.
4. Insert and fasten screws (16) and (17) in the other position.
5. Tighten all screws (15, 16, 17).
Storage
When out of use, store the device as follows:
•dry,
• with a roof overhead,
• in an upright position where it is protected from dust and direct
sunlight,
• with a plastic cover to protect it from invasive dust, if neces-
sary.
• The storage temperature is the same as the range given for the
operating temperature in the chapter "Technical data".
Transport
15
16
15
16
A.
B.
17
17