Operation Manual

B - 8 Operating Manual – Construction dryer TTK 400 EN
• After being switched on, the device operates fully automatical-
ly.
• Avoid open doors and windows.
Positioning
When positioning the device, observe the minimum distance from
walls of other objects as described in chapter "Technical data".
• Set the device in a level and stable position.
• When positioning the device, keep a sufficient distance away
from sources of heat.
• If possible, set the device in the middle of a room. If using mul-
tiple devices, ensure that the spaces between devices is equal.
• When positioning the device in wet areas, secure the device lo-
cally with an RCD (Residual Current protective Device) which
complies with the appropriate regulations.
• Ensure that extension cords are completely unrolled.
• Ensure that power supply's voltage and current comply with
the specifications on the device's nameplate.
• When using a generator, ensure that the generator supplies at
least 4 kW of power (device starting current can exceed the
nominal current by four or five times. Also note this fact when
using several devices at one generator).
Notes regarding the dehumidifying capacity
The dehumidifying capacity depends on:
• the spatial composition of the room
• the room temperature
• the relative humidity
The higher the room temperature and relative humidity, the higher
the dehumidifying capacity.
For using in living rooms, a relative humidity of approx. 50-60 %
is sufficient. In store rooms and archives, the humidity should not
exceed approx. 50 %.
Operating elements
Operation
CC
A
B
D
No. Operating element
3 Operating hours counter
10 Mains switch:
"ON": Device is switched on.
"OFF": Device is switched off.
3
9