TTK 24 E / TTK 24 E BS / TTK 24 E DS / TTK 24 WS EN TRT-BA-TTK24E/TTK24EBS/TTK24EDS/TTK24WS-TC-003-EN OPERATING MANUAL DEHUMIDIFIER
You can download the current version of the operating manual and the EU declaration of conformity via the following link: Table of contents Notes regarding the operating manual................................. 1 Safety ..................................................................................... 1 Information about the device................................................ 3 TTK 24 E Transport and storage........................................................... 4 Assembly and installation......
• • • • • • • • • • • • Ensure that all electric cables outside of the device are protected from damage (e.g. caused by animals). Never use the device if electric cables or the power connection are damaged! The electrical connection must correspond to the specifications in chapter Technical data. Insert the mains plug into a properly secured mains socket. Observe the device's power input, cable length and intended use when selecting extensions to the power cable. Completely unroll extension cables.
Behaviour in the event of an emergency Device depiction 1. Switch the device off. 2. In an emergency, disconnect the device from the mains feed-in: Hold onto the mains plug while pulling the power cable out of the mains socket. 3. Do not reconnect a defective device to the mains. 1 Information about the device 3 N TA K FU LL D R EF ST O R PE O N O FF O The device uses the principle of condensation to automatically dehumidify rooms.
Unpacking the device Transport and storage Note If you store or transport the device improperly, the device may be damaged. Note the information regarding transport and storage of the device. Transport Before transporting the device, observe the following: • Switch the device off. • Hold onto the mains plug while pulling the power cable out of the mains socket. • Drain the remaining condensate from the device and the condensation drain hose (see chapter Maintenance).
Inserting the air filter Operation Operating elements NK TA L FU L T OS FR DE ON F OF • Notes: • Avoid open doors and windows. • After being switched on, the device operates fully automatically. • The fan permanently runs in dehumidification mode. N IO AT ER OP Note Do not operate the device without an inserted air filter! Without the air filter, the inside of the device will be heavily contaminated. This could reduce the performance and result in damage to the device.
N TA K FU LL D R EF ST O R PE O N O FF O N IO AT NK TA L FU L T OS FR DE ON F OF N IO AT ER OP 4. Guide the other hose end to a suitable drain or sufficiently dimensioned collection container. Please note that the hose must not be kinked. N IO AT ER OP N TA UL KF L T OS FR DE ON F OF 2. Push one end of the hose onto the hose connection. Remove the hose if you want to collect the condensate in the condensation tank again. Allow the hose to dry prior to storage.
Shutdown Warning of electrical voltage Do not touch the mains plug with wet or damp hands. Switch off the device. Hold onto the mains plug while pulling the power cable out of the mains socket. If necessary, remove the condensation drain hose and any residual fluid from it. Empty the condensation tank, if need be. Clean the device according to the Maintenance chapter. Store the device according to the Storage chapter.
Maintenance intervals Maintenance Maintenance and care interval before every start-up Check air inlets and outlets for dirt and foreign objects and clean if necessary as needed at least every at least every at least every at least 2 weeks 4 weeks 6 months annually X X Clean the exterior X X Visually check the inside of the device for dirt X X Check the air filter for dirt and foreign objects and clean or replace if necessary X X X Replace the air filter Check for damage Check the attachment
Maintenance and care log Device number: .................................... Device type: .............................................
Activities required before starting maintenance • • Warning of electrical voltage Do not touch the mains plug with wet or damp hands. Switch the device off. Hold onto the mains plug while pulling the power cable out of the mains socket. Warning of electrical voltage Tasks which require the housing to be opened must only be carried out by authorised specialist companies or by Trotec. Cleaning the air filter Note Ensure that the air filters are neither worn nor damaged.
Emptying the condensation tank NK TA L FU L T OS FR DE ON F OF If the condensation tank is full or not installed correctly, the TANK FULL LED (10) will be illuminated. The compressor and fan will switch off. 1. Take the condensation tank out of the device. N IO AT ER OP 3. Clean the filter using a slightly damp, soft, lint-free cloth. If the filter is heavily contaminated, clean it with warm water mixed with a neutral cleaning agent. N IO AT ER OP 2.
Activities required after maintenance Disposal If you want to continue using the device: • Leave the device to rest for 12 to 24 hours, so the refrigerant can accumulate within the compressor. Wait 12 to 24 hours before switching the device back on! Acting contrary might lead to compressor damage and a malfunctioning device. If so, any warranty claims will be voided. • Reconnect the device to the mains.
Trotec GmbH & Co. KG Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.