| Assembly & Set-Up Contents of Carton . Tiller {13 . . Hardware Pack {1} . + Engine Operators Manual (1) Handlebar Support {1} Wheels/Tines PIG Lever {1} Handlebar Assembly (1) Operator's Manual (1) WARNING! To prevent personal injury or property damage, do not start the engine unit all assembly steps are complete and you have read and understand the safety and separating st ructions in this manes. Recommended Tools for Assembly + % peen-endwrench (1) © %d open-end wrench (2) . 14" open-end wrench (2) .
3. Connect the tillers main harness connection 3 to the neutral safety switch receptacle. See Flute 3-5. Emptiness Lever over the yoke plates. See Figure 3-7. To aid in the next step, insert a screw temporarily into the forward most holes of the yoke plates and the lever. PTO Drive Lever Plates. Whe Speed Lever Forward Hole Figure 3-5 Wheels/Tines PTO Drive Lever Figure 3-7 1. Loosen the Bolton the handlebar base and 4 align she rear mast holes of the yoke plates swing the handlebars out to the right side.
Engine Throttle Lever and {able For shipping purposes, the throttle cable, together with the throttle fever, is wound around the engine. Carefully unwind the cable. If the throttle control libel is covered with a clear protective coating, peel it off, WARNING! To avoid electric shock from a short circuit electric start tillers only, never allow the throttle cable to touch the battery. Route the cable below the battery, on the outside of the battery holder.