SDS

S
A
FETY D
A
T
A
SHEET
According to OSHA Hazard Communication Standard, 29 CFR
1910.1200
5 / 15
800001028894
US


Version 1.2 Revision Date: 07/07/2015 Print Date: 07/08/2015
Biological occupational exposure limits
No biological limit allocated.
Monitoring Methods
Monitoring of the concentration of substances in the breathing zone of workers or in the general
workplace may be required to confirm compliance with an OEL and adequacy of exposure con-
trols. For some substances biological monitoring may also be appropriate.
Validated exposure measurement methods should be applied by a competent person and sam-
ples analysed by an accredited laboratory.
Examples of sources of recommended exposure measurement methods are given below or con-
tact the supplier. Further national methods may be available.
National Institute of Occupational Safety and Health (NIOSH), USA: Manual of Analytical Methods
http://www.cdc.gov/niosh/
Occupational Safety and Health Administration (OSHA), USA: Sampling and Analytical Methods
http://www.osha.gov/
Health and Safety Executive (HSE), UK: Methods for the Determination of Hazardous Substances
http://www.hse.gov.uk/
Institut für Arbeitsschutz Deutschen Gesetzlichen Unfallversicherung (IFA) , Germany
http://www.dguv.de/inhalt/index.jsp
L'Institut National de Recherche et de Securité, (INRS), France http://www.inrs.fr/accueil
Engineering measures : The level of protection and types of controls necessary will
vary depending upon potential exposure conditions. Select
controls based on a risk assessment of local circumstances.
Appropriate measures include:
Adequate ventilation to control airborne concentrations.
Where material is heated, sprayed or mist formed, there is
greater potential for airborne concentrations to be generated.
General Information:
Define procedures for safe handling and maintenance of
controls.
Educate and train workers in the hazards and control meas-
ures relevant to normal activities associated with this product.
Ensure appropriate selection, testing and maintenance of
equipment used to control exposure, e.g. personal protective
equipment, local exhaust ventilation.
Drain down system prior to equipment break-in or mainten-
ance.
Retain drain downs in sealed storage pending disposal or
subsequent recycle.
Always observe good personal hygiene measures, such as
washing hands after handling the material and before eating,
drinking, and/or smoking. Routinely wash work clothing and
protective equipment to remove contaminants. Discard con-
taminated clothing and footwear that cannot be cleaned.
Practice good housekeeping.
Personal protective equipment
Respiratory protection : No respiratory protection is ordinarily required under normal
conditions of use.
In accordance with good industrial hygiene practices, precau-
NS